Nichiha, USA, Inc.

An employee was removing cardboard pieces that were causing a packaging line malfunction when the machinery moved, propelling the employee into the upper metal poles of the machine and exerting pressure on the employee's torso that caused a contusion to their liver.

An employee was trying to unclog a pipe to a discharge bag when a rotary blade inside the valve amputated the fingers on the employee's left hand. The machine was energized at the time.

An employee was changing a saw blade when the saw machine activated. The employee's left ring and little fingers were amputated.

An employee was clearing a jam from the label cutting machine when their left middle finger was partially amputated.

Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.

An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.

An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.

After clearing a plugged cement feed chute underneath a silo, the injured employee asked a coworker to "bump" the rotary feeder to confirm material flow had resumed. The rotary feeder's inspection port was open, and dust was escaping until the injured employee covered the hole. Material then built up and prevented a visual inspection inside the feeder. The injured employee then instructed the coworker at the operating switch to stop the machine. While the feeder was still rotating due to inertia, the injured employee pushed the packed material out of the inspection port. A rotating blade partially amputated their right index fingertip.

Liquid concrete was being unloaded from a ready-mix truck into a mobile dump buggy. An employee was holding the truck s chute handle while standing beside the buggy. As the dump buggy moved forward, the employee s fingertip was caught and pinched between the chute handle and the buggy s bucket. The left ring fingertip was amputated.

At approximately 3:30 PM, on 4/30/2025, a Quikrete employee was exiting a tractor trailer when he slipped and fell to the ground. The employee sustained a fractured left femur.

An employee was utilizing a 10-foot fiberglass ladder to install an antenna on the side of a one-story residential home. The height of the mounted antenna from the ground was approximately 12 feet. While completing the installation of the antenna the employee lost his balance and fell approximately 8 feet to the concrete below, resulting in two fractured heels.

An employee was on a flatbed straightening return pallets when they sustained a back injury.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.