CEMEX

An employee was opening the hood of a truck and caught a finger between the air handler and hood resulting in a laceration and hospitalization.

An employee was working to build an electrical substation. He was cleaning out the inside of a fixed section of a PVC pipe on the end that was furthest from an excavator. The excavator was outside of the trench and more than 25 feet away when it moved a pipe, pinching the employee's right arm between the two pipes. The employee's forearm was fractured.

An employee was anchored to a movable piece of equipment called a "lid" with a self-retracting lifeline harness. An overhead crane lifted the equipment, causing the employee to be pulled by his harness. The employee was pulled off the walkway and swung over the wall of the kiln. His body and head struck the wall. The employee lost consciousness and sustained a laceration to the side of his head that required stitches. The employee also sustained multiple fractured ribs and fractured vertebrae.

An employee was in a scissor lift, preparing to strip formwork from the underside of a concrete deck. As the lift was ascending, the employee's left little finger was pinched between the lift rail and the concrete beam above. The employee was hospitalized, and the soft tissue of their left little fingertip was amputated; the finger's bony tuft was also damaged.

An employee was operating an order picker when his left middle finger was crushed between the lift and storage racking. The employee's fingertip was amputated.

An employee was ascending in a scissor lift when his left thumb was caught between between the railing of the lift and a piece of equipment installed in the ceiling. The employee's thumb tip was amputated.

After clearing a plugged cement feed chute underneath a silo, the injured employee asked a coworker to "bump" the rotary feeder to confirm material flow had resumed. The rotary feeder's inspection port was open, and dust was escaping until the injured employee covered the hole. Material then built up and prevented a visual inspection inside the feeder. The injured employee then instructed the coworker at the operating switch to stop the machine. While the feeder was still rotating due to inertia, the injured employee pushed the packed material out of the inspection port. A rotating blade partially amputated their right index fingertip.

At approximately 3:30 PM, on 4/30/2025, a Quikrete employee was exiting a tractor trailer when he slipped and fell to the ground. The employee sustained a fractured left femur.

An employee was utilizing a 10-foot fiberglass ladder to install an antenna on the side of a one-story residential home. The height of the mounted antenna from the ground was approximately 12 feet. While completing the installation of the antenna the employee lost his balance and fell approximately 8 feet to the concrete below, resulting in two fractured heels.

An employee was on a flatbed straightening return pallets when they sustained a back injury.

An employee was unclogging a cement silo when the butterfly gate closed on their left thumb and crushed it, resulting in a laceration.

An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.

An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.

An employee was inspecting a generator whose radiator was leaking. He slipped, and a fan blade in the generator amputated his thumb and index finger.

An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.

An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.