Saeilo Enterprises Inc

An employee was at a firearm range for security training. As she was unloading a firearm inside a vehicle, the weapon discharged. The employee sustained a gunshot wound to the left medial knee.

An employee was test firing a 50-caliber rifle when the bullet ricocheted off a steel plate that was part of the frame for the rubber-coated bullet trap. The bullet struck the employee in the center of his neck, creating a 1/4 inch entry wound. Bullet fragments damaged the employee's trachea and the employee ingested the remaining fragments.

Employees were in a parking lot waiting to board a crew boat. An employee showed his co-workers a pistol and as he was putting it back in his truck, the gun fired. The employee sustained gunshot wounds to the right ring and little fingers.

An employee was re-holstering a gun when it went off and shot the employee in the thigh.

At about 12:15 p.m. on August 31, 2022, an employee was shooting at a gun range when his handgun fired into his right upper leg, entering above the knee and exiting at the calf.

An employee was riding as a passenger in a golf cart on a concrete pathway. The cart hit a bump and the employee fell out, suffering a head injury.

An employee was clearing a firearm that had a jam in it. To disassemble the firearm, the employee was required to pull the trigger to remove the slide. During this process, the firearm discharged and the employee suffered a bullet wound to his left hand.

On July 10, 2024, an employee developed a heat-related illness and was hospitalized with dehydration.

An employee was manually adding soda ash into a tank of heated water while on a mobile ladder. The fluid in the tank began to boil over the sides. The employee went to exit the mobile ladder to avoid the boiling liquid that was beginning to contact their lower legs. The employee lost balance and fell approximately 4 feet to the concrete below. The employee was hospitalized and had surgery for a dislocated left knee and thermal burns to the lower portion of both legs.

An employee was changing the bit on a horizontal gun drill. The wrench slipped while tightening a collet and the employee's left little finger was fractured and partially amputated.

An employee fell while exiting a trailer. The employee landed on their left side on the pavement, suffering multiple broken ribs on the left side. The employee was hospitalized.

Two employees were setting up a mandrel in the spindle of a machine. The mandrel was side-shifted while an employee's hand was on the mast of a powered industrial truck. The employee suffered crushing injuries that resulted in amputations to the middle and ring fingertips.

An employee had been loading a double deck press. The employee saw a mold had been sent in with the C-hook still attached on the belly bar. As he went to remove the hook from the mold, his right thumb got caught on the C-hook. The employee's thumb was partially amputated.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.