Tactical Safety Solutions

An employee was offloading containers from his truck using a deck that goes up and down. When the deck was up, he took a step and his foot went between the truck and the deck, resulting in a foot/ankle fracture.

An employee was using a hoist to lift large containers (420 pounds) of steel parts to be dipped into tanks. The employee set a container down on a support and his finger was caught between the container and the support, resulting in amputation just behind the first knuckle.

An employee was operating a riding mower. The employee's left hand became stuck between the mower's front left support bar and its reel. The employee suffered tendon damage to the middle three fingers.

An employee was guiding a motor into a container while a forklift was lowering it. The employee made contact with the motor, which amputated the top of his left thumb.

An employee was moving 4-inch square tubing from a pallet to a four-post rack when his right ring finger was caught between the end of a tube and the rack. The employee's finger was partially amputated.

An employee exited the ambulance van she had been driving and went to lower the hydraulic wheelchair ramp/lift on the side of the vehicle. The lift would not lower into position. She went around to enter the van to continue troubleshooting the lift when the van began to roll backward as the employee was partially out of the driver s side door. She reached in to stop the vehicle but the transmission shifted into reverse. The van turned and backed across a residential street, dragging the employee approximately 15 feet until it went up on a curb and the employee s left leg was pulled under the left front tire. She was hospitalized with fractures to her right wrist, right hand, and left fibula.

An employee was responding to an emergency call at the end of a pier when they stepped into a gap in the pier boards, resulting in a broken tibia, fibula, and ankle.

On February 19, 2025, an employee was stepping off a 4-foot metal table when he lost footing and fell to the concrete shop floor, resulting in a hip injury.

An employee was getting into the ambulance after responding to a call, slipped on the wet running board and fell to the ground. The employee struck their head and sustained a concussion.

An employee was lifting a patient weighing approximately 400 lbs. and fractured their L5 vertebra, requiring hospitalization.

An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.

An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.

An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.

Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.

An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.