GERALD PELLETIER, INC.

An employee was operating a machine when a wire pulled his right glove resulting in amputation of the index and middle fingertips.

An employee was grinding chicken when their right index fingertip was caught in the grinder and amputated.

An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.

An employee was passing through a large metal door when the door closed on the employee, resulting in a cracked rib.

An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.

An employee was working with a group of tree trimmers to trim a tree that was approximately 66 feet high and 28 inches in diameter. When the tree fell, it struck the employee. He was hospitalized with multiple fractures to the left side of his body, including his head.

On July 18, 2025, at approximately 1:09 PM, an employee was moving a trailer-mounted de-limber. He set his ground saw on the de-limber trailer and then got off the loader and stood to the side of the ground saw. A grapple skidder was raising the trailer slightly so he could throw the chain under the trailer to secure the ground saw. He then turned around and the ground saw slid off the trailer and struck his back. The employee was hospitalized with four fractured vertebrae.

On June 23, 2025, an employee was assisting with a tire replacement. As the employee was returning with tools, two co-workers were positioning the tire on the hub. The tire released pressure, causing a piece of the split rim to strike the employee. They were hospitalized with a fractured left ankle and pelvis.

An employee was cutting a tree. As they were walking away, part of the tree broke off and struck the employee. The employee sustained five broken ribs and a punctured lung.

An employee was climbing down a tree after setting a rope to allow the tree to be removed. A knot at the end of his climbing system failed and he fell from the tree, landing about 35 feet below. He suffered fractures to the pelvis and spinal cord and was hospitalized.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.