Vail Resorts

An employee was walking in the "runout" area between snow tubing lanes and was adjusting deceleration mats used to slow down the guests. A guest riding a snow tube struck the employee, knocking the employee to the ground. The employee sustained a concussion and a fractured clavicle.

An employee was riding a snowmobile to pull ropes to close off ski trails. The snowmobile's throttle opened during a turn, and the snowmobile struck a tree. The employee suffered a fracture at the base of the skull.

An employee was riding up a chairlift. Upon disembarking the lift, the employee's skis did not slide on the ramp due to ice buildup. This caused the employee to fall onto his left hip, resulting in a fracture.

An employee was teaching ski school. While demonstrating J-turns, the employee caught the edge of their ski on a pole basket, causing them to fall onto their pole handle. The employee suffered two rib fractures and a punctured lung that required hospitalization.

An employee fell while giving a skiing lesson and sustained a broken leg.

A patient stood up and then fainted, falling onto an employee. The employee sustained a back injury.

The injured employee tried to catch a co-worker who was having a seizure. Both employees fell to the floor and the injured employee sustained a broken hip.

An employee was cleaning the park and sweeping outside of the front gate. A guest bumped into the employee, causing her to fall and sustain a hip and wrist fracture.

An employee was near a co-worker who was standing on stacked milk crates stocking products. The co-worker began to fall and as the injured employee went to help, her co-worker fell on top of her. The injured employee was hospitalized with a hip fracture.

An employee went to assist a patient walking into the building. The patient fell on the employee and the employee sustained a broken femur.

An employee was trimming tree limbs from a bucket truck. The employee fell from the bucket to the ground 16 feet below, suffering a concussion and a broken rib.

Two employees were in a drive terminal, pulling a new fuel line for an EPU to provide tertiary power for a ski lift. After unspooling the fuel line, one employee took a step backward and fell through the skinning (the floor of the terminal) to the ground about 12-15 feet below. The employee suffered a dislocated ankle and fractures to the lower tibia and fibula.

An employee was doing a sweep of a mountain bike trail when their mountain bike's front tire slipped. The employee fell from the bike to the ground and suffered a broken pelvis. The employee was hospitalized.

An employee was kneeling, lighting the pilot for a gas range, when gas that had leaked from a quick coupler at the back of the range ignited. The employee suffered serious burns to both arms and her neck.

An employee was riding a mountain bike to check on markings and race trails when he struck a tree. He sustained six fractured ribs and a laceration to the spleen.

An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.

An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.

An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.