International Converter, LLC

An employee was using a rag to clean product from the doctor blade assembly component of a foil lamination machine. The roller assembly caught the rag and the employee was pulled into the point of operation and suffered a partial amputation to the right index finger. The machine was unguarded at the time.

An employee was hospitalized after his arm got caught between two rollers in the slitter machine.

An employee was assisting with pipe on a drilling rig. The slips came down and landed on the employee's left foot fracturing four metatarsals.

Two employees were struck by the rotary table of a drilling rig while installing caisson. Employee 1 suffered multiple fractures, internal injuries, and head trauma. Employee 2 suffered multiple fractures, internal injuries, spinal injury, and head trauma.

Employees were felling hazard trees. The injured employee was conducting 'bucking' operations to saw a tree from the road when the tree kicked-back, pinning him against the ground and fracturing his left femur. The employee was hospitalized and required surgery.

An employee was greasing tongs on a work-over rig. The tongs lacerated one of the employee's fingers.

An employee was chaining a vehicle when he had to change tools and the compressor. As the compressor was being charged, the employee stepped near the vehicle to make sure the compressor was attached. Then, he instructed a co-worker to lower the compressor. His right hand was on the compressor and under the chain, causing his ring finger to be crushed.

An employee was clearing a clog in the glue gun machine. When the clog cleared, his left index finger struck the fan blade, resulting in medical amputation.

An employee was operating a clamp truck to transport material to a workstation from the rear of the warehouse. The forklift was traveling near the rear baler area when another employee stepped into its path and the front right tire ran over his left foot. Their left foot and toes were crushed resulting in a dislocation and broken bones, as well as a laceration to the foot.

An employee was grinding a burr off a piece of stainless steel using a 12-inch stationary disc sander when his right thumb contacted the sanding disc, resulting in amputation at the first knuckle.

On February 16, 2023, an employee was removing a piece of film from a machine when his right thumb was pulled into the nip-point and amputated.

On December 16, 2022, an employee was feeding a book through a machine and guiding the wire when their left index finger was amputated at the first knuckle.

An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.

The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.

An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.