Nonroadway incident involving motorized land vehicle, unspecified · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at BECCO CONTRACTORS, U.S. 60 west of 169, NOWATA, OKLAHOMA 74048
on — Fractures, affecting the neck, except internal location of diseases or disorders.
Watch Becco Contractors — freeGet an email when a new federal OSHA severe-injury report for Becco Contractors is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee was operating a dozer when he was thrown out of the seat and into the roof of the dozer, fracturing his neck. A seat belt was not worn at the time.
HospitalizedNeck, except internal location of diseases or disordersBulldozers
An employee was moving a loaded lift from an aisle when it became wedged in the aisle and abruptly stopped, throwing the employee. The employee suffered a concussion, and fractures to two neck vertebrae and the left scapula.
An employee was in the basket of an aerial lift while unloading it from a flatbed trailer. The brake released, causing the aerial lift to strike another lift. The employee sustained a partially collapsed lung, rib fractures, and bleeding from the kidneys.
An employee was moving materials using an all-terrain vehicle when the vehicle struck an overhead boom. The employee's head struck against the steering wheel and he was ejected to the concrete ground. The employee was hospitalized with a head injury.
An employee was loading and unloading palletized material with a powered pallet jack. The pallet jack backed up and the employee's leg was crushed between the pallet jack and a bumper/trailer hitch, resulting in fractures to the right ankle and left tibia.
An employee was operating a forklift and went to grab a hold of the swinging arm to swing it into place. His hand was caught between the forklift and the swing arm, resulting in a middle finger amputation.
More severe injuries in this industry (NAICS 237310)
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.
A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.
An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.
An employee was working with paving equipment and heard a noise on the opposite side of the machine he was working on. When the machine stopped, the employee went to the opposite side and crouched down to investigate the noise. A mini track loader backed up and drove over the employee's leg. The employee sustained fractures to their lower leg, ankle, and foot.
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.
An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.
An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.
An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.