Struck by falling object or equipment, n.e.c. · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Zachry Industrial, Inc., 10986 GA HWY 87, JULIETTE, GEORGIA 31046
on — Amputations, affecting the fingertip(s).
Final narrative
Two employees were breaking a seal between the pulverizer and the pyrite seal box using a prybar. Once the seal was broken, a five-inch gap was left between the two. The injured employee's left hand was in the gap between the pulverizer and the seal box. As they slid the box, it dropped three inches off the shims and onto the injured employee's left hand resulting in an open fracture and amputation of the pinky fingertip.
An employee was walking on site when he tripped on a wooden survey stake that was lying flat on the ground. He fell into another employee and sustained a fracture to the tibia/fibula.
An employee was working on top of a rebar mat that was about 4 feet off the ground. As he walked across the mat, he stepped into a gap and his lower leg was caught in the rebar. His right leg twisted, and he suffered fractures to the tibia and fibula. He was hospitalized.
A Zachry Industrial employee was pushing a cart up a walkway. A forklift struck the employee as it finished turning around, its back right wheel hitting the employee's left foot and causing multiple fractures.
An employee was welding the bottom of a chute on the underside of a bin. Hot material came through a small gap between a gate inside the bin and the chute, contacting the employee below. The employee received second and third burns to the neck.
An employee was working to fit two 1-1/2-inch stainless steel spool pieces at a flanged connection to bolt up.
To align the two spool pieces, the top section of pipe (10 feet in length) was rigged using a nylon strap choker, attached to a 1/2-ton chain.
As the employee attempted to move the pipe, the load shifted in the nylon strap, causing the top section of the pipe to drop approximately 1-2 inches, which pinched the injured employee's left index finger in the flanged connection and resulted in an amputation of the finger's distal tip.
An employee was moving a piece of an I-beam for welding when it rolled off the cribbing. The employee went to catch it when it fell and crushed the employee's finger, resulting in a partial amputation.
An employee was helping to disassemble large reels used to store steel wire when a 264-pound flange from the reel fell over onto the employee's left leg. The employee sustained multiple fractures to their leg and ligament injuries to the lower leg.
The injured employee was putting away materials on the warehouse floor as a co-worker was pushing a pallet onto a nearby shelf. The pallet knocked another pallet forward, causing it to fall onto the injured employee's shoulders. The employee suffered fractures in their right and left knees and ankles.
Employees were moving a single man lift into a building and reclining the lift to position it to fit through the door. The lift shifted and fell, causing the employee to sustain fractures to the left tibia and fibula. The employee was hospitalized and had surgery.
An employee was moving a light tower so it could be hitched to a truck. He grabbed the tongue of the trailer hitch on the light tower to slide it to the left. The tongue jack fell off, causing the light tower tongue to drop on the employee's right hand. The employee's middle fingertip was amputated.
More severe injuries in this industry (NAICS 811310)
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.
An employee was operating a lift truck when it struck a stationary lift truck. His left thumb was pinched between the two lift trucks, resulting in a partial amputation.
An employee was disassembling a pressurized unit using a driver drill. When the unit was disassembled, it caused a kickback from the tube head, causing the drill to strike the employee's left forearm. They sustained a diaphyseal fracture to their left radius and ulna, which required surgery.
After repairing a piece of industrial equipment, an employee had brake-cleaning liquid on his gloves. A lighter ignited the liquid, and the employee's hands were severely burned.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.