Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Kurt Manufacturing, 302 Jeffers Ave., LYMAN, NEBRASKA 69352
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Watch Kurt Manufacturing — freeGet an email when a new federal OSHA severe-injury report for Kurt Manufacturing is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee was attempting to take a part out of a punch press machine's point of operation when the machine actuated, crushing her right index finger and resulting in an amputation.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 332323)
A temporary employee was performing a two-person projection welding task to add a hinge reinforcement to a hollow steel door. He was positioning the hinge reinforcement while his supervisor held the door to maintain alignment. When the foot pedal was actuated, the electrode partially amputated the employee's left ring finger.
An employee was stacking bundles (12 feet long, 21 inches high) of aluminum extrusions (weighing 28 pounds each). After three bundles had been successfully stacked, the fourth tipped over when it was partially complete. It landed on the employee's right ankle/leg and broke the tibia. The employee was hospitalized.
An employee was adjusting the rollers on the mill feeder when their right thumb was crushed between two rollers, resulting in amputation of the thumb tip.
An employee was operating a core drill to bore through concrete at an active construction site. The equipment struck embedded rebar in the concrete, causing the handle to kick back and strike the employee's ribs. The employee was hospitalized with a fractured rib and a punctured lung.
An employee was loading pallets onto a truck and climbed down off a pallet after loosening straps to release the crane. The employee slipped off the flatbed truck and fell 4 feet to the dock plate/ground. The employee was hospitalized with a brain bleed and fractures to their T4, T5, and T6 vertebrae.
An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.
An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.
An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.
An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.