105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

Alfa Laval Inc.

Injured by slipping or swinging object held by injured worker · Amputations

Federal OSHA recorded a severe workplace injury at Alfa Laval Inc., 1201 S. 9th Street, BROKEN ARROW, OKLAHOMA 74012 on — Amputations, affecting the finger(s), fingernail(s), n.e.c..

An employee was using a hand-held drill to ream a hole in a sheet metal bracket held in a vice. The injured employee was attempting to remove a wire loop from the hole being drilled when his glove was caught in the bit. The glove pulled the middle finger on his left hand into the bit, causing cartilage and tendon damage that resulted in a finger amputation.

Amputation Finger(s), fingernail(s), n.e.c. Drills-powered

Alfa Laval Inc.

An employee was working in the hydro department putting a bolt into a metal header when he struck his hand and right index finger on the metal header. He was hospitalized for an infection.

Alfa Laval Inc.

An employee was using a pin press machine to put pins in the back of a heat exchanger louver blade. His right hand was caught between the blade and a hydraulic component, causing a partial amputation to the index fingertip.

Alfa Laval Inc.

An employee was securing the air seal on a motor mount when another employee, who was attempting to lower a fan assembly, loosened the come-along on the load and the fan assembly shifted, pinning the injured employee into the motor mount. The employee's head was crushed, breaking several bones in his face.

Alfa Laval Inc.

An employee lacerated a finger when it was caught in a press brake.

View Alfa Laval Inc.'s full OSHA safety record →

Mako Contracting, LLC

An employee was using a saw to cut a piece of concrete when the piece gave way and pushed the saw into the employee's leg. The employee's leg was lacerated, requiring stitches and hospitalization.

East Penn Manufacturing

An employee was using a utility knife to cut honeycomb paper when the knife amputated their left index fingertip.

Ash Brothers Fireplace and Chimney Co

An employee was cleaning a resident's chimney. While using a drill, the employee's glove became caught in the drill and their finger was fractured.

RPM & Associates Inc

An employee was grinding some hardfacing on a bulldozer blade when the 9-inch grinder kicked back and lacerated his left leg above the knee. The employee was hospitalized and required surgery.

Tenaris Hickman

An employee was operating a rotating tool to place thread protectors on the end of pipe. Her left hand was on the rotating part of the tool when the tool engaged, resulting in a left forearm fracture and a thumb laceration.

General Thermodynamics, Inc.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

Applied Cooling Technologies, LLC

An employee was laying underneath a cooler block while jacking up the tie bar to secure it to horses when the cooler block fell off the horses and onto the employee, resulting in several fractures to the pelvis, clavicle, wrist and tailbone.

CT/HX, LLC

An employee was climbing a ladder on a water cooling tower when they fell approximately 15 to 20 feet to the ground, resulting in a fractured left elbow.

Chart, Inc.

An employee was preparing to sand a metal shaft that was loaded into a lathe when his left arm became entangled in the machine. The employee sustained several broken bones.

Chart, Inc.

An employee was removing the banding from a load of mechanical supports, when one fell forward onto his left leg. The employee sustained a laceration to the lower leg and was hospitalized.

Rae Corporation

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

Meeco Sullivan

An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.

Edward Jones Investments

An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.

Burgess Manufacturing of Oklahoma Inc.

An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.