Ignition of vapors, gases, or liquids · Heat (thermal) burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Petro Harvester Operating Company,LLC, 1119 West 6th Street, LAUREL, MISSISSIPPI 39440
on — Heat (thermal) burns, unspecified, affecting the nonclassifiable.
Final narrative
An employee was inserting a hand held wand with a burning cloth attached to the end into a 4" opening of the main burner valve to ignite the pilot. The flame ignited residual gas and burned the employee.
HospitalizedNonclassifiableCoal, natural gas, petroleum fuels and products, unspecified
More severe injuries at Petro Harvester Operating Company,LLC
An employee was investigating the condition of the flame inside an oilfield separation vessel when the sight glass cover was expelled, allowing the heat to burn and blister the employee's right cheek.
An employee was cleaning a cordless drill. As they applied brake fluid to the drill and pulled the trigger, the fluid ignited. The employee suffered burns to the face, hands, and arms.
An employee was spraying glue to the floor of an enclosed cargo trailer. The fumes made contact with the heater causing a flash fire. The employee suffered burns to their face and right hand.
An employee was replacing a valve in the gas line to the fryer. The shutoff valve malfunctioned resulting in a gas leak that then ignited. The employee sustained burns requiring hospitalization.
An employee was slipping pipe when it became stuck and the pipe snapped, striking the employee in the back and ribs. The employee sustained fractured ribs.
An employee was standing on an injector head feeding chain with a rope, when the rope broke, causing him to lose his balance and fall to the ground. The employee sustained fractures to his left elbow and three ribs.
An employee was pulling drill line from the drill spool while the top drive was not set on the docking pins. The deadman was unexpectedly released which caused the top drive to fall to the drill floor from a height of 30 feet. This caused the drill line that was being pulled out and laid on the ground to retract and strike an employee. The employee suffered fractures to his legs and neck.
An employee was conducting maintenance on a pipe and was using a T-bar tool to secure the retainer cap on a pump. The employee's left index finger was caught in the rotating pump, resulting in a partial amputation.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.