Struck by object or equipment, n.e.c. · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Wisco Moran Drilling Company, Inc., Drilling Rig #7, PLACEDO, TEXAS 77977
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Watch Wisco Moran Drilling Company, Inc. — freeGet an email when a new federal OSHA severe-injury report for Wisco Moran Drilling Company, Inc. is published. One employer, no account, unsubscribe in one click.
Final narrative
On May 8, 2018, at approximately 12:10 a.m., employees were running some traded pipes and casing. The crew had a problem connecting two pipes (casing), so they unscrewed those pipes and continued to work with the casing. The injured employee's left hand was on top of an open pipe when a hoist operator (driller) let a second pipe come down. The employee's left-hand fingers were caught between the two pipes (casing), resulting in an amputation of his index finger and a broken ring finger.
An employee was inspecting a bridge repair project. A gas-powered, walk-behind pavement saw, being used 12 feet away from the employee lunged forward, cutting his left foot. The employee's fourth toe was amputated and he was hospitalized.
An employee had been reviewing an insulated glass unit. The employee was placing the glass unit back in its box when it slipped out of the box and a chipped corner lacerated the employee's left hand.
An employee was on a truck while using a clamp to secure a quartz slab to an A-frame on the truck. A gust of wind pushed the slab onto the employee, resulting in a dislocated right shoulder and wrist.
An employee was shearing off two inches of metal when the metal kicked up and struck his hand. The employee's left ring and middle fingertips were amputated.
An employee was working on a 35,000-pound I.D. fan. As the employee rotated the blades with his foot, the blades continued to spin, lacerating his right foot and amputating a toe.
More severe injuries in this industry (NAICS 213111)
An employee was stepping down off a 6-inch containment platform to finish loading his truck, when his right ankle rolled. The employee sustained a fractured tibia and fibula at the right ankle and required surgery.
A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.
An employee arrived on location and loaded a blow-out-preventer (BOP) on a 1-ton flatbed truck. While standing on the flatbed securing the the BOP, the employee stepped into a void/hole on the flatbed surface. This caused him to lose balance and fall off the truck bed with his leg still caught in the hole. As a result, he sustained fractures to his left leg.
An employee was rigging up a location. He was using an Allen wrench to free up rotation and start the drawworks engine manually. The engine rotated and his left little finger became caught between the Allen wrench and the engine. The employee sustained an amputation to his little finger and fractures to his wrist.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.