Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Webster Combustion, 619 Industrial Road, WINFIELD, KANSAS 67156
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was using a sheet metal roller machine to make a part and was attempting to straighten a piece when the roller caught the employee's left hand, amputating the little and ring fingers.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 332410)
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
An employee was laying underneath a cooler block while jacking up the tie bar to secure it to horses when the cooler block fell off the horses and onto the employee, resulting in several fractures to the pelvis, clavicle, wrist and tailbone.
An employee was climbing a ladder on a water cooling tower when they fell approximately 15 to 20 feet to the ground, resulting in a fractured left elbow.
An employee was preparing to sand a metal shaft that was loaded into a lathe when his left arm became entangled in the machine. The employee sustained several broken bones.
An employee was removing the banding from a load of mechanical supports, when one fell forward onto his left leg. The employee sustained a laceration to the lower leg and was hospitalized.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.