Struck by powered vehicle-nontransport, n.e.c. · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Gagnon Line Construction, Inc., 2499 Lebanon Road, GLEN SPEY, NEW YORK 12737
on — Fractures, affecting the multiple trunk locations.
Final narrative
An employee was working from the extended boom/basket of a bucket truck. The outriggers of the bucket truck were not set on solid ground, resulting in the outrigger sinking into the ground as the boom was further extended. The truck became unstable and collapsed with the employee inside the basket. He rode the bucket to the ground and fractured his back and ribs.
HospitalizedMultiple trunk locationsBoom truck, bucket or basket hoist truck
An employee was going to fill a pallet with items from the warehouse. He was reaching for the handle of the pallet jack but unintentionally grabbed the throttle, causing the pallet jack to move and pin him against another pallet jack. The employee sustained a leg fracture.
An employee was loading merchandise onto rolling containers that were on a remote-operated order picker. While reorganizing merchandise to prevent top loading, the employee's wireless control device contacted a container and caused the order picker to move forward. The employee's right ring finger was caught between two containers and was amputated above the first knuckle.
The injured employee was operating an elevator at a construction site. He went from the tenth floor to the eleventh floor with a plumber and a scissor lift in the elevator. The plumber was using a remote to operate the scissor lift. As the scissor lift was exiting the elevator, a pipe that was on the scissor lift struck the injured employee's chest. The employee was hospitalized.
An employee was dismantling the engine from a vehicle. The vehicle slid off the loader and struck the employee, pushing him into his toolbox. The employee sustained a broken jaw.
More severe injuries in this industry (NAICS 237130)
An employee was terminating cables in a junction box. A loose ground wire came into contact with the bushing, causing a flash that burned the right side of the employee's face and his right hand.
An employee was using a bucket truck hoist to raise secondary aerial wiring. The wire made contact with the primary wire, causing an arc flash. The employee suffered burns to both hands and was hospitalized.
An employee was terminating conductors to buss bars inside the secondary compartment of a single-phase transformer. An arc flash occurred, causing burns to the soft tissue of the employee's face.
An employee was securing the claw of a grapple truck to the truck bed. His left little finger was caught between the tie down strap and the rub rail of the truck, resulting in partial amputation of the finger.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.