Novinium, Incorporated

An employee was making modifications to an electrical panel when an arc flash occurred. The employee suffered burns to multiple parts of the body.

An employee was installing a ground wire to a power transmission pole. The ground wire contacted an energized portion of a cut-out, causing an arc-flash. The employee was hospitalized with second degree burns to their chest and arms.

An employee was connecting a utility transformer for underground service to a home. The employee's impact drill went across two connection bars with 240 volts of potential, creating an arc flash. The employee sustained burns to the face and eyes due to the arc flash and molten aluminum.

On December 15, 2023, at 9:15 AM, an employee was changing 60-amp fuses in a 480-volt panel when an arc flash occurred. The employee was hospitalized with burns to both hands.

An employee had just turned off breakers and was loosening wires on panels when they were shocked by 480 volts of electricity.

An employee's left bicep was lacerated by high-pressure water during water blasting operations. The employee was hospitalized.

An employee was performing flagging operations on a closed road. A postal vehicle was allowed onto the road to make a delivery. The employee was struck by the postal vehicle as it was backing up, resulting in a broken leg.

An employee was walking and taking post-locate photos. He stepped on a ceramic drainage tile and his foot/leg punched through the tile. His leg was lacerated by the broken tile. The employee was hospitalized with internal bleeding due to a punctured femoral artery.

Employees were preparing to place a section of metal grating measuring approximately 50" x 18" and weighing 40 to 50 lbs. The injured employee grabbed the grating to pull it toward himself and another employee was moving to the other side to assist with the lift. As the injured employee pulled, his right foot slipped and twisted. He was hospitalized with a fractured right leg.

An employee was in their personal vehicle awaiting instructions from the construction contractor on posting traffic cones. The driver of a motor vehicle swerved to avoid a steel plate in the roadway and struck the employee's car. The employee was hospitalized with four fractured ribs.

An employee was drilling a hole into the sealed hold of a vessel so a marine chemist could test its atmosphere. Upon drilling the hole, a gas that was under pressure was released and caught fire at the drill motor, where the employee was holding it. The employee was burned.

An employee was performing restoration activities outside a 45-gallon condensation tank of a boiler system. As they were performing post-maintenance activities after repairing one of the two discharge pumps, one of the discharge valves would not open. The employee closed the intake pump to cool off the system and open the discharge valve. Two employees opened the inlet valve to return the tank to service. After they cracked open the inlet valve, a side wall of the tank blew out, causing the injured employee to suffer steam burns to half their body.

An employee was testing and troubleshooting the gang cylinder valve located in the gang area of the sawmill. The employee's fingertip was amputated by the gang cylinder valve.

An employee was unlocking containers on deck. The employee was de-lashing while standing on the edge of the lid. The lashing bar he was holding came off the cone, causing him to turn 90 degrees and strike a railing behind him. The employee sustained four fractured ribs.

An employee parked a side-by-side on the fixed internal ramp aboard a cargo ship. They exited the side-by-side and went to inspect the cargo below. The side-by-side rolled toward the employee and struck them as they were walking toward the edge of the ramp. The employee was knocked off the ramp and landed on the lower deck approximately 8 feet below. The employee was hospitalized with a fractured shoulder.