Overexertion in lifting-single episode · Soreness, pain, hurt-nonspecified injury
At a glance
Federal OSHA recorded a severe workplace injury
at Lanxess Corporation, 5701 Murray St., LITTLE ROCK, ARKANSAS 72209
on — Soreness, pain, hurt-nonspecified injury, affecting the back, including spine, spinal cord, unspecified.
Final narrative
An employee was hospitalized for back spasms after lifting a stack of seven 9.5-pound parts into a box.
HospitalizedBack, including spine, spinal cord, unspecifiedContainers-variable restraint, n.e.c.
An employee was walking up the stairs at a bromine loading/unloading area. A thermal expansion rupture disc failed in a chlorine dock area, about 70 yards away. The employee inhaled chlorine gas, suffered lung irritation and low blood oxygen, and was hospitalized.
On 12/22/2023, an employee was carrying bins filled with pasta to a refrigerator. As he lifted a 20-pound bin, he felt pain in his lower back. The employee sustained a herniated disc.
An employee was lifting a patient when they pulled a back muscle. She suffered back pain and spasms radiating into her leg with weakness and numbness. The employee's L3-L4 disc was herniated and she was hospitalized.
An employee was lifting a bundle of insulation with a colleague when he felt severe pain in the right side of his lower back/hip region. The employee sustained a severe muscle injury.
More severe injuries in this industry (NAICS 325199)
Two employees were lifting a roll of steel poly bar (50 inches and approximately 150 pounds) from ground level to a height of 4 feet at the 66-inch rubber calendar. One employee dropped the roll, resulting in the poly bar contacting the injured employee's right knee. The employee was hospitalized with fractured right patella.
Employees were loading a 295-pound transformer onto a pickup truck using a forklift. The injured employee was acting as the spotter. The transformer hit the tailgate of the pickup truck and the spotter's right hand was struck by the transformer, resulting in amputation of the ring fingertip.
An employee was wearing full PPE while emptying a 55-gallon drum of phosphorus pentoxide and fainted, collapsing and striking their head against the ground. The employee was hospitalized and it is likely that heat caused by wearing full body PPE contributed to fainting.
An employee was troubleshooting a plug in the super-absorbent polymer line. The employee opened an inspection port and their right hand was caught in a rotary valve, resulting in the amputation of four fingers between the knuckle and the first joint.
An employee was conducting a quality control measure by taking a chemical sample for lab analysis. When the employee was opening the sample point, it broke off and crude 2-Ethylhexyl thioglycolate (EHTG) shot out at 265 degrees, and it covered the employee's legs and right arm and splashed the right side of their face. The employee was hospitalized with first- and second-degree burns to their right thigh, lower right knee, inner left thigh, and upper left forearm.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.