Direct exposure to electricity, unspecified · Electrical burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at W. W. Gay Mechanical Contractor, Inc., 5510 NW 27th Ave. , GAINESVILLE, FLORIDA 32606
on — Electrical burns, unspecified, affecting the hand(s), unspecified.
Final narrative
An employee was on a ladder unhooking the ground clamp of a welding machine with the right hand when the employee grabbed a piece of conduit with the left hand for support and received an electric shock. The employee suffered a burn to the right hand around the thumb and ring finger.
HospitalizedHand(s), unspecifiedWelding machinery
More severe injuries at W. W. Gay Mechanical Contractor, Inc.
On November 12, 2022, an employee was helping to move a bundle of boiler tubes. As the sling was being reset, a bundle of steel tubes dislodged from the wall mount, striking the employee in the head. The employee sustained head injuries.
On October 27, 2021, the injured employee was helping another employee to align two pieces of metal pipe 6 inches in diameter in order to prepare the metal for welding. The employee was using a hammer to hit the pipe to get it better aligned when the injured employee's right middle finger was hit by the hammer, resulting in a fingertip amputation without bone loss.
An employee was climbing on a baker's scaffold to reach a working platform when the scaffold turned over on top him. He fell approximately 6 to 8 feet to the ground, puncturing his lung and requiring hospitalization.
An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.
An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.
An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.
An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.
On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.
More severe injuries in this industry (NAICS 238220)
An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.
An employee was closing the side cargo door to a company van. The tip of his finger got caught between the door and the door jamb, resulting in a partial amputation.
While working at a customer's residence, an employee was cutting tape with a box cutter to wrap insulation for a piece of pipe. The box cutter struck a hardened object within the wall causing it to bounce back and puncture the employee's right eye. The employee was hospitalized.
An employee was assembling a baker type scaffold. He was beginning to transverse down the scaffold, approximately six feet off the ground, when the scaffold tipped over and he fell. The employee was hospitalized with a fractured femur.
An employee was trimming out sprinklers on the exterior of a building when he fell off an extension ladder. He landed on the ground and sustained fractures to his nose and arm.
An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.
An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.
An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.
An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.