ABRA Auto Body and Glass

An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.

An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.

An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.

An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.

On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.

An employee was kneeling on his left knee with his right knee up while taking measurements of a car he was working on. As he switched knees, and put his right knee on the ground with his left knee up, his right hip dislocated and he bent forward onto his hands. The employee was hospitalized and required hip surgery.

An employee was finishing up using a resistance welder on a vehicle. After finishing, he removed his gloves and picked up the resistance welding arm with his left hand on the hydraulic cylinder and his right hand on the handle. The button on the handle was activated and the hydraulic cylinder engaged, catching the tip of his left little finger and resulting in a fingertip amputation.

An employee was working to attach a safety handle to the cable portion of a pulley system designed to aid in the operation of a resistance welder. The tension on the cable was disengaged, then reengaged while the employee's left hand was on the top of the pulley system. The cable caught the tip of the employee's left little finger, causing an amputation at the first joint.

At about 8:00 a.m. on August 8, 2025, an employee was holding a metal coupon for another employee to use in demonstrating spot-welding technique to a third, student employee. A metal hole puncher was activated and crushed the employee's left middle finger, resulting in an amputation to the finger. The incident occurred during a training activity.

An employee was closing the gate at the end of the day when it missed a latch and came off its track. The gate fell onto him, resulting in hospitalization with a fractured femur that required surgery.

An employee fell while moving a water canister, resulting in fractures to four fingers on her right hand.

An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.

An employee was mixing sauce using a sauce barrel mixer when his left little finger was amputated.

An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.

A temporary employee was carrying a nail gun through the warehouse when it hit his leg, activated, and fired a nail into the leg.