FLEET READINESS CENTER SOUTH WEST

An employee was painting markings on an aircraft while standing on a pair of stands, 8-9 feet from the ground. He stepped into a gap between the stands and fell about 3 feet, his foot hitting a stand brace. He suffered a twisted left knee and a shoulder separation.

On October 26, 2021, an employee was working on a combine. While exiting the cab of the combine, the employee squatted down to see the front of the combine. The employee then felt pain in their lower back. The employee was hospitalized with a slipped disc in the lower back.

While using a screw gun, an employee tweaked his back and had to be hospitalized.

Two employees fell from an access bridge while entering an aircraft to perform maintenance. They landed on the ground about 20 feet below, where one of them lost consciousness. One employee sustained a fractured knee and another employee sustained a back strain/sprain. Both employees were hospitalized.

An employee experienced sharp pain in his lower torso area while loading baggage into the front cargo pit of an aircraft. The employee sustained a hernia.

The injured employee was assisting in the disassembly phase after a radar array had been lowered and secured. The crew began removing load bearing pins from an overhead crane to free the radome. A load bearing pin was stuck. The injured employee went to remove the pin manually as a second team member applied pressure from the opposite side. The pin unexpectedly released and struck the injured employee s right thumb, resulting in partial amputation of the distal phalanx including an open distal phalanx fracture and nail bed laceration.

On September 11, 2025, an employee was lowering a railing system on an aircraft fueling cart when his gloved right ring finger was caught in the folding railing system, resulting in a fingertip amputation that required hospitalization and surgical reattachment.

An employee was working at ground level when an aviation engine cylinder weighing 30 pounds fell from a seven-foot high shelf and struck the employee on the head. The employee suffered a fractured skull and was hospitalized.

The injured employee was assisting a Department of Homeland Security (DHS) enforcement operation. During an apprehension, officers returned fire at a subject and struck the employee with a bullet. The employee sustained a gunshot wound to their right hand.

The injured employee was assisting in the disassembly phase after a radar array had been lowered and secured. The crew began removing load bearing pins from an overhead crane to free the radome. A load bearing pin was stuck. The injured employee went to remove the pin manually as a second team member applied pressure from the opposite side. The pin unexpectedly released and struck the injured employee s right thumb, resulting in partial amputation of the distal phalanx including an open distal phalanx fracture and nail bed laceration.

An employee was working on an electrical panel in a mechanical room when an arc flash occurred. The employee suffered burns.

At about 3:10 p.m. on October 3, 2025, an employee was inspecting a car. Two dogs that had been in another car were leashed and tethered to a bollard. As the employee inspected the first car along with a narcotics detection dog, one of the other dogs came loose and attacked the narcotics dog. The employee was separating the dogs when the other dog bit his left ring finger. The last joint of the finger was injured and part of it was bitten off.

An employee was preparing a bundle of green onions for chopping. While holding the bundle in his left hand, he made his first cut using a 9-inch kitchen knife held in his right hand. The knife contacted the tip of his left thumb, resulting in an amputation of approximately 0.5 inches of the thumb that required hospitalization.