Charter Spectrum

An employee was preparing a tank car for loading while chipping away solidified product in the manway opening of the tank car. A pressure noise within the tank car startled the employee, causing him to stumble backward and fall approximately 10 feet over the guard railing at the chemical loading rack to the ground. The employee suffered fractured vertebrae, a fractured right wrist and ankle, and a dislocated jaw.

An employee was installing an electrical tray remover from a ladder. As he was descending, his missed a step and fell 6-7 feet to the floor. The employee suffered a head injury.

Two employees were installing spray foam insulation in the attic of a new residential construction. The injured employee fell 8 feet from an A-frame ladder to the floor. The employee suffered lacerations, abrasions, and a head injury.

An employee was on a raised platform attaching wires to electrical boxes. The employee fell approximately 8 feet to the floor below and struck an exit sign on the way down, resulting in an injury to his face.

An employee was in a forklift man basket fixing a garage door opener when they fell approximately 8 feet to the concrete ground below. The employee suffered head and back injuries as well as kidney bruising.

An employee was adjusting a cable reel that was loaded onto the forks of a forklift. The reel shifted and caught the employee's left index fingertip against the backrest, amputating it.

An employee was on an extension ladder, about 15-18 feet high, while spraying a wasp nest on a telecommunications pole. He fell to the ground and sustained fractures to his hip, requiring hospitalization.

An employee was moving a pan through the pan building and was struck by the superstructure of a crane, resulting in a fractured hip.

An employee was working from a ladder, pulling a cable line through a wall at a customer's house. He lost his balance and jumped off the ladder, landed on the ground about 7 feet below, and suffered injuries to both ankles including a fracture to at least one. The employee was hospitalized.

An employee was pulling inner duct from one handhole to another. The shackle on a winch cable contacted the cable sheave's roller block. The employee released tension on the winch cable and lifted the cable to guide the shackle over the lip of the handhole. As he re-engaged the winch, his left index fingertip became caught between components in the winch's retrieval wheel. The fingertip was amputated between the last knuckle and the nail.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.