MILWAUKEE, WISCONSIN—
Wisconsin Bell, Inc.
Struck by rolling, sliding, or shifting objects non-running · Amputations, avulsions, enucleations unspecified
At a glance
Federal OSHA recorded a severe workplace injury at Wisconsin Bell, Inc., 435 South 95th Street, MILWAUKEE, WISCONSIN 53214 on — Amputations, avulsions, enucleations unspecified, affecting the Finger or thumb tip(s), nail(s).
Final narrative
An employee was adjusting a cable reel that was loaded onto the forks of a forklift. The reel shifted and caught the employee's left index fingertip against the backrest, amputating it.
Similar incidents · Same event type
CORSICANA, TEXAS—
Greenbrier Rail Services
An employee was using his left hand to push an axle down the line on a raised track work area while holding the remaining axle back with his right hand. A finger on his right hand was caught between the rail and the dust guard of the axle, resulting in a fracture and a laceration.
LAKE CITY, FLORIDA—
New Millennium Building Systems
An employee was moving metal out of a cart. He had removed one piece and was working to move another when the metal shifted. His right ring finger was crushed between the two pieces, and he suffered a partial amputation to the finger pad at the tip.
PITTSBURGH, PENNSYLVANIA—
Triad Metals International
A load of steel angles was being lowered when the lifting chain hit the load, causing it to slide toward an employee. An angle slid and pinched the employee, catching both of their legs between the beams and an angle. The employee suffered two fractured legs.
FORT WORTH, TEXAS—
Renegade Group LLC
Employees were replacing a 24" pig trap door. A strap was shackled on the pig trap door and connected to a forklift. Welders began to cut the door off. An employee was holding onto the door when the cut was finished. The door shifted and caught his fingers, resulting in a hand injury and amputation.
NORTH JACKSON, OHIO—
Universal Stainless & Alloy Products Inc.
An employee used a crane to set down a bar. The bar measured 9 inches by 16 feet. The strap got stuck under the bar, and the employee asked another employee to jog the roll. The bar rolled and pinched the injured employee's left hand, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 517919)
CREEDMOOR, TEXAS—
Spectrum - Charter Communications
An employee was on an extension ladder, about 15-18 feet high, while spraying a wasp nest on a telecommunications pole. He fell to the ground and sustained fractures to his hip, requiring hospitalization.
NEWINGTON, NEW HAMPSHIRE—
SUBCOM CABLE SYSTEMS, LLC
An employee was moving a pan through the pan building and was struck by the superstructure of a crane, resulting in a fractured hip.
SACO, MAINE—
Charter Communications
An employee was working from a ladder, pulling a cable line through a wall at a customer's house. He lost his balance and jumped off the ladder, landed on the ground about 7 feet below, and suffered injuries to both ankles including a fracture to at least one. The employee was hospitalized.
CLEWISTON, FLORIDA—
Hypower, LLC
An employee was pulling inner duct from one handhole to another. The shackle on a winch cable contacted the cable sheave's roller block. The employee released tension on the winch cable and lifted the cable to guide the shackle over the lip of the handhole. As he re-engaged the winch, his left index fingertip became caught between components in the winch's retrieval wheel. The fingertip was amputated between the last knuckle and the nail.
SHREVEPORT, LOUISIANA—
AT&T Garage
An employee had been laying cable in the sun for a full work day and later became unconscious. The employee was hospitalized for heat stroke.
More severe injuries in WISCONSIN
MADISON, WISCONSIN—
RG Professional Carpenter, Inc.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
FRANKLIN, WISCONSIN—
General Thermodynamics, Inc.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
SAINT CLOUD, WISCONSIN—
Sargento Foods Inc
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
HIXTON, WISCONSIN—
Asher Enterprises, Inc.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
VERONA, WISCONSIN—
Consolidated Electrical Distributors Inc.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.