Struck against moving part of machinery or equipment · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Builders FirstSource , 200 Cody Lane, SHERMAN, TEXAS 75092
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was feeding material into the in-feed trough of a saw. While the material was being automatically fed by the in-feed device, his right hand came into contact with the activated blade, resulting in the amputation and partial amputation of his right index, middle, and ring fingers. The saw blade was guarded at the time.
An employee was unloading trusses from a trailer. The trusses slid off the side of the trailer and struck the employee, who suffered fractures to the ribs, femurs, left hip, and left arm.
An employee was using a V-nailer to staple a door casing together and used his right hand to line the casing up and hold the casing in place. The foot pedal was activated and the clamp came down on his right little finger amputating the fingertip just below the fingernail.
An employee was standing on the ground beside his tractor trailer and strapping down his load. A forklift crushed him against the trailer as it backed past him. He suffered a broken pelvis and internal bleeding.
An employee was climbing an 8-foot step ladder and stopped at the second step from the top to secure a beam that a forklift was placing in the building. The beam then fell toward the employee, causing him to fall backward and hit his head on the concrete slab below. The employee suffered a fractured skull.
An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.
An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.
An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.
An employee was unloading freight from a truck when a stack of doors fell over and knocked the employee to the ground. The employee sustained a fractured femur.
An employee was performing rebar fabrication using a bending machine. The employee's glove became caught in the area where the rebar bend overlaps onto itself. The subsequent bending/cutting caused the two overlapping portions to squeeze together and amputate approximately 1/4" of his left index fingertip.
An employee was building wood detail blocking and a wood member needed to be resized. The employee took the wood member to the table saw and set the fence to the correct size. The employee pressed down on the board to control it when his left little finger contacted the running blade, resulting in an amputation.
An employee was clearing a pipe along a culvert using a motorized plumbing machine. The end of the machine got tangled and stuck in long grass and other debris. The employee went to lift the end of the machine out of the grass and clear the blockage when his hand was pulled into the machine, resulting in a partial amputation and open fracture of his left distal phalanx.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.