Caught in or compressed by equipment or objects, n.e.c. · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Midwestern Machine-Hydraulics, 17265 N Timberline Ln, MOUNT VERNON, ILLINOIS 62864
on — Amputations, affecting the fingertip(s).
Final narrative
A temporary employee was putting a cylinder on a pallet when his left hand was smashed between the pallet and cylinder, resulting in a fingertip amputation.
AmputationFingertip(s)Machine and appliance parts, n.e.c.
An employee was offloading containers from his truck using a deck that goes up and down. When the deck was up, he took a step and his foot went between the truck and the deck, resulting in a foot/ankle fracture.
An employee was using a hoist to lift large containers (420 pounds) of steel parts to be dipped into tanks. The employee set a container down on a support and his finger was caught between the container and the support, resulting in amputation just behind the first knuckle.
An employee was operating a riding mower. The employee's left hand became stuck between the mower's front left support bar and its reel. The employee suffered tendon damage to the middle three fingers.
An employee was guiding a motor into a container while a forklift was lowering it. The employee made contact with the motor, which amputated the top of his left thumb.
An employee was moving 4-inch square tubing from a pallet to a four-post rack when his right ring finger was caught between the end of a tube and the rack. The employee's finger was partially amputated.
More severe injuries in this industry (NAICS 811310)
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.
An employee was operating a lift truck when it struck a stationary lift truck. His left thumb was pinched between the two lift trucks, resulting in a partial amputation.
An employee was disassembling a pressurized unit using a driver drill. When the unit was disassembled, it caused a kickback from the tube head, causing the drill to strike the employee's left forearm. They sustained a diaphyseal fracture to their left radius and ulna, which required surgery.
After repairing a piece of industrial equipment, an employee had brake-cleaning liquid on his gloves. A lighter ignited the liquid, and the employee's hands were severely burned.
An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.
An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.