105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

Hillspoint Technical Solutions, Inc.

Direct exposure to electricity, unspecified · Electrical burns, unspecified

Federal OSHA recorded a severe workplace injury at Hillspoint Technical Solutions, Inc., 14647 Delaware St. , WESTMINSTER, COLORADO 80023 on — Electrical burns, unspecified, affecting the multiple body parts, n.e.c..

Watch Hillspoint Technical Solutions, Inc. — free Get an email when a new federal OSHA severe-injury report for Hillspoint Technical Solutions, Inc. is published. One employer, no account, unsubscribe in one click.

An employee was kneeling down, working on a dead panel box, when an arc flash and explosion occurred in the adjoining panel. The employee suffered burns to the face and arms and was hospitalized.

Hospitalized Multiple body parts, n.e.c. Switchboards, switches, fuses

Bob Woodall Air Care Systems, Inc.

An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.

Amentum Spaceport LLC

An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.

Marsh Bellofram Corporation

An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.

Heart Utilities of Jacksonville, Inc.

An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.

Duke Energy Florida, LLC

On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.

Scada Systems LLC

Employees were changing out a level switch on a vessel when the switch flew off under pressure and struck an employee's face. The employee sustained fractures and lacerations to their face.

NCR Voyix Corporation

An employee had just completed a repair at a customer's store and was leaving via the main entrance. A suspected shoplifter ran by (while being chased by the police) and shoved the employee into a shelving unit. The employee suffered a broken elbow and a chin laceration and was hospitalized, requiring surgery.

Newpark Mats & Integrated Services

An employee was operating a perimeter router. He reached to move the router out of the way so he could advance a panel when he suffered the amputation of the distal phalanx on his left index finger.

General Dynamics Mission

An employee lifted a gearbox from one shipping container to another. The employee sustained a ruptured hernia and required surgery.

IQUEST AUTOMATION, INC.

An employee was pulling out an extension cord when its plug flew back and struck the employee's eye. The cornea was scratched.

ABC Supply Company

An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.

Burke Builders Inc

An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.

Circle Graphics, Inc.

An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.

FLATIRON CONSTRUCTION CORP.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

Takkion OPS Management

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.