Struck by object or equipment dropped by other person · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Linetec, 7500 Stewart Ave., WAUSAU, WISCONSIN 54401
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee and a coworker were moving an aluminum extrusion weighing approximately 43 pounds when the coworker dropped his end. The employee's right middle finger was inside the extrusion at the time and suffered an avulsion that required surgical amputation.
AmputationFinger(s), fingernail(s), n.e.c.Structural metal materials, unspecified
Employees were tasked with installing permanent jumpers. The injured employee was inside the insulated bucket with the jumper inside the bucket. The jumper contacted an energized phase while he was moving, causing the employee to sustain burns to his left leg and foot.
An employee opened up a machine cover to setup the strut line and was using his left index finger to feel underneath the extrusion to check the adjustment. His finger was pulled into the pinch point created by the crimping disk. The fingertip was medically amputated.
On February 25, 2016, an employee was inspecting parts on the transfer table when the rotating shaft grabbed the employee's glove and amputated his left thumb.
On February 27, 2015, an employee severely injured his finger while moving a 50-pound vise in the Rack Maintenance Area. The employee crushed the upper portion of the right pinky finger. Medical providers removed the untreatable portion of the finger between the first and second knuckle.
The injured employee was standing at the base of a ladder assisting another employee install a TV on a wall. The TV was dropped, striking the employee. They sustained a head injury.
An employee and a colleague were moving two pieces of rebar when a tie was cut. The employee holding the rebar dropped it while it was above the injured employee's hands, resulting in partial amputation to their left middle finger.
An employee was bracing an extension ladder while his coworker installed a 10-foot, 40-45-pound pipe. The pipe fell onto the injured employee's head and he sustained a hematoma, C3 and C4 vertebral fractures and a forehead laceration.
An employee was helping to lift a press roll in to fix an issue that was occurring. A co-worker lost their grip and the press roll fell onto the injured employee's left index finger, resulting in a crush injury and amputation.
Three employees were removing equipment from an old fermentation room at a bakery. They were using two bakery dollies to remove metal plates from the floor of the room. One of them was holding one of the metal dollies with his right hand on the side of the dolly, as a plate was being centered on the two dollies. The plate slipped and struck his right thumb, which was amputated near the last joint.
More severe injuries in this industry (NAICS 332321)
On October 14, 2025, an employee was cutting lumber on an upcut saw. When he activated the saw to cut a short piece, the blade struck the tip of his right thumb, resulting in a partial amputation.
An employee was using a table saw to cut strips of plywood. The employee's left hand came into contact with the sawblade, which amputated the index and middle fingers as well as lacerating the hand. The employee was hospitalized, requiring surgery.
An employee was loading four sliding glass door panels into a truck. He was turning to get a cargo strap when the panels fell onto him and broke his neck.
An employee was using a table saw to cut a small bundle of vinyl material. The saw blade lacerated the employee's left index finger. The employee was hospitalized.
An employee had finished installing hurricane shutters on a customer's home and was putting his tools away and changing clothes. His hands began to cramp; he got out of his truck and collapsed on the road. He suffered an acute kidney injury and rhabdomyolysis caused by dehydration and heat illness.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.