Contact with hot objects or substances · Heat (thermal) burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at ABM Aviation, Inc., Terminal 5, CHICAGO, ILLINOIS 60666
on — Heat (thermal) burns, unspecified, affecting the multiple body parts, n.e.c..
Final narrative
On October 21, 2018, an employee was working with another employee to replace a low temperature hot water pump. When he went to disconnect the pump, the water sprayed on him, scalding his left arm and the left side of his torso. The water line to the pump was not turned off at the time of the incident.
An employee was walking inside an airport terminal when his radio fell down. As he went to pick it up, he lost his balance and fell onto his right knee, fracturing it. He was hospitalized.
An employee connected a steam line to a hose to clean equipment when the fitting broke loose. They were struck by steam in the left inner thigh, resulting in burns that required hospitalization.
An employee was making tea when she noticed tea grinds were collecting on the side and water was no longer dripping through the funnel. The employee was checking the funnel when boiling water and tea grinds spilled onto the left side of her body. The employee sustained burns to her neck, back, and arm.
An employee had turned off the ball valve on a waterpipe system and was removing the plug when the coupling system attached to the strainer came apart. Hot water sprayed on his arm and back, resulting in first- and second-degree burns that required surgery.
An employee was using a shovel to remove waste vermiculite from molten zinc. The metal had been placed in a bin and partially hardened. The employee broke through the partially hardened metal; still-molten metal flowed to the employee's steel-toed right boot and entered through the cloth boot tongue. The employee suffered a third-degree burn to the right foot and was hospitalized.
More severe injuries in this industry (NAICS 621910)
An employee exited the ambulance van she had been driving and went to lower the hydraulic wheelchair ramp/lift on the side of the vehicle. The lift would not lower into position. She went around to enter the van to continue troubleshooting the lift when the van began to roll backward as the employee was partially out of the driver s side door. She reached in to stop the vehicle but the transmission shifted into reverse. The van turned and backed across a residential street, dragging the employee approximately 15 feet until it went up on a curb and the employee s left leg was pulled under the left front tire. She was hospitalized with fractures to her right wrist, right hand, and left fibula.
An employee was responding to an emergency call at the end of a pier when they stepped into a gap in the pier boards, resulting in a broken tibia, fibula, and ankle.
On February 19, 2025, an employee was stepping off a 4-foot metal table when he lost footing and fell to the concrete shop floor, resulting in a hip injury.
An employee was getting into the ambulance after responding to a call, slipped on the wet running board and fell to the ground. The employee struck their head and sustained a concussion.
An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.
An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.