Caught in running equipment or machinery, unspecified · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Cooper Tire & Rubber Co., 2205 Martin Luther King Blvd., CLARKSDALE, MISSISSIPPI 38614
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was attempting to remove rubber from a mixer door when his left arm entered the mixer, resulting in a left middle finger amputation and crushed left ring finger.
AmputationFinger(s), fingernail(s), n.e.c.Special process machinery, n.e.c.
An employee was overseeing the process of emptying a condensation pit into a relief pit. While observing a pump, hot steam from a condensation tank leaked out onto the employee resulting in first and second degree burns to their back, the backside of both arms, and the backside of both legs.
An employee was using a pry bar on a hot mold in a tire change press. His left pinky finger contacted the hot mold, resulting in a burn. He was hospitalized for an infection.
On June 5, 2016, an employee was unloading a semi trailer using a forklift. She picked up a load, drove approximately 8 feet, and exited her lift. The forklift then rolled forward and pinned her between the load on the lift and another skid, breaking two legs and requiring hospitalization.
An employee was removing a spacer from the curing press when a bolt that was holding up the support leg for another piece of equipment (platen) broke. The support leg fell on the employee's right middle finger, smashing it.
On December 19, 2023, an employee was setting up a copper wire drawing machine when his left ring finger was pinched between a copper wire and a machine part. The employee's finger was partially amputated.
An employee was checking the gusset seal on a machine. He moved to the next cross sealer and the machine activated, causing an amputation to a left-hand finger. The employee was hospitalized.
An employee was evaluating a coiling machine to verify that the blade was present inside it. The machine's weld function was activated, and the machine crushed the employee's fingers, resulting in the amputation of the left middle and ring fingers.
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
An employee was adjusting a pallet on a conveyor when it came off the conveyor and struck his right ankle, breaking the tibia and fibula. The employee was hospitalized.
At 2:45 p.m., an employee was outside the plant during a break before his next shift. He was speaking with an associate when he suddenly fell from the third-level steps to the ground, striking his head on the concrete. The employee was hospitalized due to internal brain bleeding, a wound to the back of his head requiring staples, and heat-related dehydration.
Two employees were replacing a motor on an overhead conveyor. The old motor fell to the floor, causing a piece of the concrete floor to fly up and strike the injured employee in the face, around the eye. The injured employee sustained a right orbital fracture, a zygomatic arch fracture, and a sphenoid fracture. The employee was hospitalized and required surgery.
An employee was changing the bladder on a hydraulic press. As he lowered the bladder, his left foot was pinned between its bottom ring and the bottom mold of the press. The second toe on the foot was amputated.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.