Direct exposure to electricity, greater than 220 volts · Electrical burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at National Grid, Unionville Substation, DELMAR, NEW YORK 12054
on — Electrical burns, unspecified, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was doing maintenance work in a substation. As the employee inspected a piece of electrical equipment, an electrical flash occurred in the equipment. The employee's finger was burned.
An employee was going to inspect a gas line for damage after the gas line was struck during excavation. The employee was looking into the excavation site when he fell 3 feet into the trench and sustained a left wrist laceration that required surgery and hospitalization.
An employee was descending a step ladder when he contacted a pry bar that was in the ground next to the ladder. The employee sustained a laceration to the leg and buttocks.
An employee was helping to reposition a newly set pole that was being held by a digger derrick. While the winch line and choker chain were under tension, the employee started to rotate the pole. A link of the chain pinched the employee's left ring finger against the pole. The finger was fractured and the fingertip amputated, but was able to be reattached.
An employee was working on a part in the test facility when they made contact with an energized part; 7620 volts of electricity entered their body in the stomach area and exited through their hand, resulting in electrical burns. The employee was hospitalized.
An employee was assisting two co-workers in unloading a pallet jack from a pickup truck bed. The pallet jack began to fall and the employee reached to stop it when his hand went into the pallet jack and his fingertip was amputated by the force of the pallet jack falling down onto his finger.
An employee was installing a ground wire to a power transmission pole. The ground wire contacted an energized portion of a cut-out, causing an arc-flash. The employee was hospitalized with second degree burns to their chest and arms.
An employee was connecting a utility transformer for underground service to a home. The employee's impact drill went across two connection bars with 240 volts of potential, creating an arc flash. The employee sustained burns to the face and eyes due to the arc flash and molten aluminum.
On December 15, 2023, at 9:15 AM, an employee was changing 60-amp fuses in a 480-volt panel when an arc flash occurred. The employee was hospitalized with burns to both hands.
An employee was troubleshooting the control setup for a variable air volume box above a ceiling. The employee's hand came into contact with an exposed, energized 277-volt wire that had loosened from its terminal on the box's assembly. He was shocked and fell off a ladder. His left hand passed across the ceiling grid and was lacerated. He also suffered an electrical burn to the right hand and was hospitalized.
An employee was moving a scissor lift through a doorway. The employee was pinned between the scissor lift and the doorframe, sustained a back injury, and was hospitalized.
An employee was standing on an A-frame ladder approximately 6 feet above the floor while he attached a suspended light fixture to the ceiling. The employee lost balance, and fell to the tiled floor below, sustaining blunt force trauma to his head.
An employee was inspecting the overhead area of a single-person lift and repositioning the lift through a double doorway. As they were transitioning through the doorway, they were caught between the doorframe and the vertical mast of the lift. The employee was hospitalized with injuries to the nose, left maxillary sinus, left orbital bone, and left jaw, with fractures at the maxillary sinus area.
The injured employee was performing routine maintenance on a fan belt/pulley. The injured employee and another person were moving the pulley back and forth manually to find a bearing issue. The injured employee's left ring finger got caught between the belt and the pulley wheel, resulting in a soft tissue amputation.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.