Abernathy Company

An employee was using a clamp fork truck to load a railcar with rolls of material. The employee exited the lift to put a mat between two of the rolls. The roll held by the fork truck's clamp (60 inches, weighing 3,000-3,500 pounds) dropped from the clamp onto his arm, covering it from hand to bicep. He sustained compartment syndrome, with blood clots, in the arm.

An employee was moving a 55-gallon drum of hydrofluoric acid onto a pallet on a forklift. The employee pushed the drum with his hands and knee. Approximately 1 hour later, he noticed his pant leg was wet and recognized the acid odor. He suffered 2nd degree burns to his knee cap and was hospitalized.

An employee was drying and finishing vehicles when a vehicle door closed on their left middle fingertip and amputated it.

An employee was climbing down from a tractor trailer bed when they lost their footing and grabbed onto the roll-up door to stop the fall. The roll-up door then fell onto the employee's hand, resulting in a hand fracture that required surgery.

An employee was attempting to remove a tarp from a flatbed trailer when the trailer handle struck the employee in the chest, resulting in two broken ribs and a punctured lung.

An employee was near a backhoe while the operator was getting a broom. The broom handle struck the lever that actuates the swing of the backhoe bucket. The bucket then struck the injured employee, pinning him to the outrigger. The employee suffered crush injuries to the chest.

The injured employee was being trained on loading trucks in the load out bay. The injured employee and his supervisor climbed the stairs that run parallel to the truck and trailer, walked to the upper platform used for observation and sample taking, and saw that the lid of the grain trailer was closed. The employees began working to open the lid which appeared to be stuck due to cold weather. The injured employee pulled on one of the pivot arms that connect the lid to the main body of the trailer. As the lid began to open, the employee s right hand slipped down on the pivot arm and his index finger was caught between the pivot arm and the base of the pivot arm. The employee s right index finger was fractured and three nerves were severed. The employee was hospitalized.

On October 30, 2025, an employee was working to adjust a stackable metal shipping container. As the container dropped into place, it caught the employee's hands in an area between the upper and lower cross-members. The employee suffered a laceration to the left ring finger that required stitches, bruising to the right ring finger, and fractures to the right middle finger that necessitated medical amputation of the fingertip.

A temporary employee was punched in the face by another temporary employee. He suffered a laceration to the eye.

An employee was backing up a powered industrial vehicle. Her left hand was caught between the vehicle and a rack, and the wrist was broken.

An employee was operating an extruder and performing a spool swap over from the right spindle to the left spindle. After rewiring the new spool, the employee's clothing got caught in the turning shaft when the left spindle started back up. The employee's left arm was pulled into the machine, resulting in a fractured humerus and lacerations to her triceps. She was hospitalized and required surgery.

An employee was resetting a warehouse racking system utilizing an order picker. They fell approximately 5 feet from the order picker to the concrete floor and sustained fractured ribs.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.