Berlin City Auto Group - Honda

An employee was operating a band saw when his right little fingertip was amputated.

An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.

An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.

An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.

An employee was using a shaper to cut wood when their right hand contacted the blade, resulting in a partial amputation to the right ring finger.

An employee was repairing the suspension of a semi-trailer. He was installing an air bag to the suspension when his left ring finger was crushed between the air bag and the suspension mounting beam. The employee was hospitalized.

An employee was refueling a pressure washer when it ignited and exploded. He suffered multiple third-degree burns to his chest and hands.

A mechanic had just finished a repair on a straight truck with a flatbed , which had been lifted using a bottle jack. As the employee was about to remove the jack, it failed. The truck shifted forward, dropped down, and struck the employee's chest. He suffered broken ribs and a broken shoulder.

An employee was performing diagnostic work on a vehicle engine. As the employee was leaning over the front of the vehicle, the engine was activated. A fuel leak had produced fumes around the engine, and the ignition spark ignited them. The employee suffered second-degree burns to both hands, both biceps, and the upper chest area.

An employee was hot patching a tire, which involves lighting a flammable liquid on fire to patch the tire. The flammable liquid contacted his arm, and he sustained burns to his arms and face.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.