Direct exposure to electricity, unspecified · Electrical burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Cayuga Milk Ingredients, LLC, 15 Eagle Drive, AUBURN, NEW YORK 13021
on — Electrical burns, unspecified, affecting the multiple body parts, n.e.c..
Final narrative
Employees were pulling electrical wires to facilitate the installation of a new air compressor. While pulling wires, the wall/barrier inside of an electrical cabinet contacted buss bars located in an adjacent cabinet creating an electrical arc blast. One Cayuga Milk Ingredients, LLC employee and two contractor employees were burned on the hands, neck, back and face. Two of the employees were hospitalized.
HospitalizedMultiple body parts, n.e.c.Switchboards, switches, fuses
An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.
An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.
An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.
An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.
On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.
More severe injuries in this industry (NAICS 311514)
An employee was preparing for a clean-in-place (CIP) process and removed a cap from a pipe to connect another pipe. Hot water (approximately 170 degrees) splashed onto the employee, causing burns to her hands, left forearm, and both thighs.
An employee was checking an inline magnet. The magnet was placed on a cart next to another magnet and the magnets moved toward each other. The employee's right ring fingertip was caught and amputated.
An employee was walking near a spring-mounted valve when the valve opened. Steam was released and burned the employee's arm, resulting in hospitalization.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.