Struck by object falling from vehicle or machinery-other than vehicle part · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at KELLER TECHNOLOGY CORPORATION, 2320 MILITARY ROAD, TONAWANDA, NEW YORK 14150
on — Fractures, affecting the lower leg(s).
Final narrative
An employee was helping a forklift operator stabilize a load in the top pallet. The employee steadied the load while the operator adjusted the forks. The top pallet slipped and struck the employee in the right leg, breaking the tibial plateau.
An employee was transporting an 800-pound die on a cart from the tool room. The employee was pulling the cart when it struck a metal plate on the floor. This caused the cart to tip forward and the die to slide off the cart. The die struck the employee's left foot and their second toe was amputated.
An employee was using a forklift to load pallets of product on a trailer. He exited the forklift to adjust a pallet by hand. The pallet fell on him, resulting in an injury to the left leg.
An employee was lifting a 500-pound steel counterweight off a pallet using a magnetic hold jib crane. The counterweight detached from the crane and the employee sustained a left foot/toe fracture that required surgery.
An employee was using a pipe wrench to turn a 42-foot-long steel pipe on jack stands to weld the bottom portion. The pipe fell off the stands, striking the injured employee on his left shin. The employee sustained a left leg fracture at the shin area as well as a tibia fracture that required surgery.
More severe injuries in this industry (NAICS 332710)
An employee was positioning dunnage on a trailer while pipe was unloaded from a forklift. A pipe fell and the employee's right thumb and index finger were caught between the pipe and a piece of dunnage. The thumb was crushed, and the index fingertip was amputated.
An employee was using a lifting sling on a crane to move a straight-bar bundle and place it on top of an existing bundle. When moving the lifting sling, it became pinched between the bundle and a wood cleat. The bundle then fell onto the employee's left foot, resulting in crush injuries.
An employee was stacking metal tubes using a forklift. A stack became unstable and the employee got out of the forklift to steady it, instructing his helper to get into the forklift. The forklift movement caused some tubes to fall and strike the employee, resulting in an open fracture of his left hand.
An employee was setting up a flexible gear coupling hub in a lathe, preparing to bore it out to fit a shaft. The hub assembly was not secured in the chuck when the crane support was removed, and the employee's right little finger was caught between the hub assembly and the inside of the lathe. The fingertip was amputated.
An employee was using a crowbar to loosen a flat bar when the crowbar struck the employee's right eye. The employee was hospitalized and required surgery.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.