Direct exposure to electricity, unspecified · Electrocutions, electric shocks
At a glance
Federal OSHA recorded a severe workplace injury
at Tyson Foods, 4700 Hwy 75 South, SHERMAN, TEXAS 75090
on — Electrocutions, electric shocks, affecting the bODY SYSTEMS.
Final narrative
An employee was welding in a maintenance shop when the welder shocked him.
HospitalizedBODY SYSTEMSWelding, cutting, and blow torches
An employee was trimming beef when the knife came out of his hands and punctured his abdomen as he went to grab it. The employee sustained an open abdominal wound with no internal injuries.
An employee was rigging two hooks together that were attached to a pallet and pulled by a forklift. The employee's finger slid under the secondary hook attached to the forklift and sustained a left index fingertip amputation.
An employee was helping mechanics remove a piece of iron from an airlock. The employee was approximately 3 feet up on a ladder when he dropped a wrench, which struck the handle of the steam line valve. The valve opened and steam sprayed onto the employee, causing burns to both inner thighs and his lower abdomen.
An employee was bending over, setting up a pallet on the floor. As she stood up, she lost balance, slipped, and fell to the floor, sustaining a fractured right ankle.
An employee was operating a forklift and scanning a barcode. The employee went to exit the lift when his left foot struck the edge of the lift, causing him to fall to the floor. The employee was hospitalized for a hip fracture.
An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.
An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.
An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.
An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.
On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.
More severe injuries in this industry (NAICS 311999)
An employee was reaching for a piece of angle iron when it fell onto his hand, which was on a table to support him as he reached for the overhead rack. He suffered a broken finger and was hospitalized, requiring surgery.
An employee was working to open the liftgate on the back of a delivery truck. His left middle finger was pinched between the gate and its frame, resulting in a fingertip amputation.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.