Revolution Industrial LLC

An employee was operating a machine when a wire pulled his right glove resulting in amputation of the index and middle fingertips.

An employee was grinding chicken when their right index fingertip was caught in the grinder and amputated.

An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.

An employee was passing through a large metal door when the door closed on the employee, resulting in a cracked rib.

An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.

An employee fell from a step ladder while reaching for a tie-off point. He impacted the ground, and landed on his bolt bag which contained tools. The employee was hospitalized with fractured ribs, and a lacerated spleen and kidney.

An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.

An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.

An employee was unloading a rebar delivery from a flatbed, 19-wheel trailer. The employee rigged the load with wire rope chokers. The load was picked up 3-4 feet above the trailer deck by a crane. The load began to swing and the employee grabbed onto it to prevent it from being pushed off the trailer deck. The crane continued to lift the load, and the employee let go so the crane did not lift him to the third story. The employee fell approximately 12 feet to the ground below, resulting in a back injury and fractured vertebrae.

An employee was attaching a steel angle plate weighing (approximately 200 pounds) to the end of a structural member (5,000 pounds) and was supported by dunnage. The dunnage was a crane mat (11 inches tall) with a 4x6 board on top of it and it supported five identical members. The main piece was 30.75 feet long, 37.25 feet tall, and 1 food wide. As the employee slid the piece of metal on top of the member to begin attaching it, the entire member began to tip over. The employee went to stop the main piece from tipping over and it landed on his ankle, fracturing it.

On September 25, 2025, an employee climbed an aluminum extension ladder and was on top of the roof of a building She was walking around on the roof, inspecting and evaluating it. She was descending the ladder when the ladder slid to the right and twisted around as she hung onto it. She then fell 10-12 feet to the paved parking lot and the ladder landed on top of her. She sustained a fractured left collarbone, multiple other fractures, and had bruising to the left side of her abdomen.

At about 5:55 p.m. on August 9, 2025, an employee lost his footing while climbing an access ladder to a 12-foot-high spotlight platform. He fell about 9 feet to the ground, breaking eight ribs on the right side.

On August 1, 2025, an employee was preparing to initiate canine training when they were bitten by a dog on the neck and face.

An employee was completing an annual work capacity test. Later that night, the employee experienced severe pain in their left leg and was hospitalized with rhabdomyolysis and compartment syndrome in the lower left leg.

An employee was setting chains to secure a concrete barrier to a front-end loader. The chain became twisted and lost slack. The concrete barricade fell on the employee's left foot, causing a partial amputation to a toe.