Injured by slipping or swinging object held by injured worker · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Pernix Guam LLC, Andersen AFB, YIGO, GUAM 96929
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was using a drill with a hole saw attachment to cut holes for bar ties on a wall form. The drill's chuck snagged his work glove and his left little finger was amputated.
An employee was attempting to remove a 1/2 inch drill bit from a battery operated drill equipped with a keyless chuck. The employee was wearing cotton rubber palm gloves and squeezing the keyless chuck to remove the bit. As he pushed the trigger increasing the torque to the keyless chuck his grip slipped and the bit caught the fingertip of his glove twisting it and his fingertip into the bit causing lacerations and a fracture to the employee's left index fingertip.
An employee was using a saw to cut a piece of concrete when the piece gave way and pushed the saw into the employee's leg. The employee's leg was lacerated, requiring stitches and hospitalization.
An employee was grinding some hardfacing on a bulldozer blade when the 9-inch grinder kicked back and lacerated his left leg above the knee. The employee was hospitalized and required surgery.
An employee was operating a rotating tool to place thread protectors on the end of pipe. Her left hand was on the rotating part of the tool when the tool engaged, resulting in a left forearm fracture and a thumb laceration.
More severe injuries in this industry (NAICS 237990)
A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.
An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.
Employees were securing the fuel line of an outboard motor in preparation for removing the motor from a small vessel located in the equipment yard. A gasoline-related fire occurred and one employee sustained burns to both hands and forearms.
A marine diver/construction worker was working underwater, using a hydraulic dredge to clear sediment away from the base of a dam. The dredge's suction nozzle began migrating toward him, and then pulled in his right hand and forearm. He sustained compartment syndrome in the hand and forearm.
An employee was standing on a sheet of -inch by 4-foot by 8-foot plywood on top of a rebar mat, supervising his crew. As he was moving to alert the crew to an incoming overhead load, he stepped off the plywood and his left foot slipped through the rebar mat and landed on the rebar mat below. His left ankle was broken and dislocated.
An employee was moving a ramming machine to a staging area. While using the controls on the side of the machine, there was a sudden heavy rainfall causing the equipment to slide. The ramming machine tipped over and caught the employee against the ground. The employee sustained a fracture to the right side of their pelvis and was hospitalized.
During prep work and installation of formworks, a metal plate slid and caught an employee's left thumb. The employee suffered an open fracture to the last joint of the thumb and required surgery. The employee was hospitalized.
At 10:20 a.m. on August 11, 2025, an employee slipped on a damp sidewalk covered with a thin layer of algae. The employee suffered multiple fractures to the left femur and was hospitalized, requiring surgery.