Struck by swinging or slipping object, other than handheld, n.e.c. · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Universal Plant Services, Inc, 1384 Iron Horse Road, MCPHERSON, KANSAS 67460
on — Fractures, affecting the thigh(s).
Final narrative
An employee was attempting to pull an exchanger using an air winch and a pulley. A chain securing the winch broke, causing the winch to lurch forward. The winch struck the employee in the leg, causing a broken left femur.
HospitalizedThigh(s)Drums, pulleys, sheaves
More severe injuries at Universal Plant Services, Inc
An employee was descending a 30-foot ladder and slipped, falling approximately 5 feet to the ground. The employee sustained fractured vertebrae and a fractured ankle requiring hospitalization.
While removing sections of steel piping, an employee grabbed the cable of a winch. His left hand was pulled into the snatch block between the cable and pulley, crushing four fingers.
A crew was pulling a 4-inch plastic gas pipe off a reel and straightening it for installation. The injured employee stepped up on the trailer to cut the last band holding the pipe in the coil on the reel. As he turned to step off the trailer, the end of the pipe rotated and sprung out of the cage surrounding the coil, striking the employee on the side of the head and knocking him off of the trailer into the roadway. The employee suffered head trauma that required hospitalization.
An employee and a co-worker were performing a pick inside a clear well. They rigged the skid pan that was full of broken concrete. When lifting, the load began to swing toward a wall. The employee tried to stop the skid pan from swinging and was struck by the pan, resulting in fractures to their left hip and wrist.
The employee had just completed refueling a lattice crane that was breaking up material and was winding the fuel hose back into the fuel truck when he was struck by the catwalk/stairs of the crane. The employee was hospitalized with a laceration to his backside, possible internal bleeding, and a broken hip.
An employee was fusing 10-inch black rubber utility pipes together using a pipe fusion machine and could not get the pipes to set correctly. The employee used a nylon strap attached to an excavator to lift one side of a pipe off a steel plate. As his hand was between two pipes, the pipes came back together, partially amputating two of his fingers.
An employee was lifting four bags of a lime blend weighing approximately 10,000 pounds using a crane. The load swung and pinned the employee against a structural I-beam, resulting in fractures to the hip and pelvis.
More severe injuries in this industry (NAICS 238290)
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.
An employee was assisting with cutting a vertical steel pile. A 16-foot by 9-inch section of pile dropped to the side and bounced off a previously cut pile and toward the employee. The employee was struck in the torso and leg, causing his knee to dislocate from his femur. The employee was hospitalized.
On July 30, 2025, an employee was utilizing a circular saw to cut plastic into strips that would be used as shims. The blade of the saw amputated his left little finger to the second knuckle.
An employee was working on the ingot loader of a aluminum processing machine and noticed a pin was not installed. The employee reached to retrieve the pin and the machine activated for a functions test. The machine closed on the employee's hand, resulting in a hand injury requiring hospitalization.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.