Caught in running equipment or machinery, unspecified · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at KDC One Northern Labs , 5800 West Dr., MANITOWOC, WISCONSIN 54220
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was adjusting a capper. The drive chain and sprocket caught and injured the employee's right hand, causing the amputation of three fingers.
On September 23, 2019, a blow mold assembler suffered a crushing injury to her left middle finger in the nail area, resulting in a partial finger amputation.
On December 19, 2023, an employee was setting up a copper wire drawing machine when his left ring finger was pinched between a copper wire and a machine part. The employee's finger was partially amputated.
An employee was checking the gusset seal on a machine. He moved to the next cross sealer and the machine activated, causing an amputation to a left-hand finger. The employee was hospitalized.
An employee was evaluating a coiling machine to verify that the blade was present inside it. The machine's weld function was activated, and the machine crushed the employee's fingers, resulting in the amputation of the left middle and ring fingers.
An employee was tightening a connection on an arsine cylinder within an arsine fill cabinet. The employee was exposed to arsine gas and started experiencing symptoms a few hours later. The employee was hospitalized for exposure to arsine gas.
An employee was aligning a box before palletizing. The machine loaded another pallet and trapped the employee at the knees, resulting in skinned/bruised shins.
On September 24, 2024, an employee was using a powered industrial truck (PIT) to pick orders. His right foot made contact with an unmanned PIT, resulting in severe lacerations to three toes on his right foot.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.