Direct exposure to electricity, greater than 220 volts · Electrical burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Entergy Texas, 3019 S. San Gabriel Street, HEARNE, TEXAS 77859
on — Electrical burns, unspecified, affecting the multiple body parts, unspecified.
Watch Entergy Texas — freeGet an email when a new federal OSHA severe-injury report for Entergy Texas is published. One employer, no account, unsubscribe in one click.
Final narrative
On April 23, 2019, an employee was testing the voltage on a 34.5-kV, 4160/2400 step-down transformer when an arc flash burned the upper right part of his body. He was hospitalized.
HospitalizedMultiple body parts, unspecifiedPower lines, transformers, convertors
An employee was installing a ground wire to a power transmission pole. The ground wire contacted an energized portion of a cut-out, causing an arc-flash. The employee was hospitalized with second degree burns to their chest and arms.
An employee was connecting a utility transformer for underground service to a home. The employee's impact drill went across two connection bars with 240 volts of potential, creating an arc flash. The employee sustained burns to the face and eyes due to the arc flash and molten aluminum.
On December 15, 2023, at 9:15 AM, an employee was changing 60-amp fuses in a 480-volt panel when an arc flash occurred. The employee was hospitalized with burns to both hands.
An employee was slipping pipe when it became stuck and the pipe snapped, striking the employee in the back and ribs. The employee sustained fractured ribs.
An employee was standing on an injector head feeding chain with a rope, when the rope broke, causing him to lose his balance and fall to the ground. The employee sustained fractures to his left elbow and three ribs.
An employee was pulling drill line from the drill spool while the top drive was not set on the docking pins. The deadman was unexpectedly released which caused the top drive to fall to the drill floor from a height of 30 feet. This caused the drill line that was being pulled out and laid on the ground to retract and strike an employee. The employee suffered fractures to his legs and neck.
An employee was conducting maintenance on a pipe and was using a T-bar tool to secure the retainer cap on a pump. The employee's left index finger was caught in the rotating pump, resulting in a partial amputation.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.