105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

Triad Metals International

Struck by rolling, sliding, or shifting objects non-running · Fractures

Federal OSHA recorded a severe workplace injury at Triad Metals International, 3480 Grand Avenue, PITTSBURGH, PENNSYLVANIA 15225 on — Fractures , affecting the Leg(s) unspecified.

A load of steel angles was being lowered when the lifting chain hit the load, causing it to slide toward an employee. An angle slid and pinched the employee, catching both of their legs between the beams and an angle. The employee suffered two fractured legs.

Hospitalized Leg(s) unspecified Beams and rails metal

Triad Metals International

An employee was lifting metal tubing with a crane when one of the lifting chains became caught on a wooden block sticking out from under a tube. The load shifted, and a tube fell from a stack of bundled tubing onto the employee resulting in fractures to their jaw, arm, and leg.

View Triad Metals International's full OSHA safety record →

Greenbrier Rail Services

An employee was using his left hand to push an axle down the line on a raised track work area while holding the remaining axle back with his right hand. A finger on his right hand was caught between the rail and the dust guard of the axle, resulting in a fracture and a laceration.

New Millennium Building Systems

An employee was moving metal out of a cart. He had removed one piece and was working to move another when the metal shifted. His right ring finger was crushed between the two pieces, and he suffered a partial amputation to the finger pad at the tip.

Renegade Group LLC

Employees were replacing a 24" pig trap door. A strap was shackled on the pig trap door and connected to a forklift. Welders began to cut the door off. An employee was holding onto the door when the cut was finished. The door shifted and caught his fingers, resulting in a hand injury and amputation.

Universal Stainless & Alloy Products Inc.

An employee used a crane to set down a bar. The bar measured 9 inches by 16 feet. The strap got stuck under the bar, and the employee asked another employee to jog the roll. The bar rolled and pinched the injured employee's left hand, resulting in a fingertip amputation.

ADFORS Saint-Gobain

An employee was releasing air from an inflatable mandrel which was loaded onto a fork truck. The mandrel was moved by the fork truck and the employee's finger got caught in the hole where the air release button is located. The employee's fingertip was amputated without loss of bone.

Ryder System Inc.

An employee was on the deck of a trailer helping a customer unload tubes. The employee was working to place a cargo strap on the remaining tubes using a winch bar when it slipped off the tubing, causing him to lose his balance and fall headfirst onto the asphalt lot below. The employee suffered a contusion on his forehead, resulting in hospitalization.

EASTERN METAL SUPPLY, INC.

An employee and a customer were unloading two rectangular tubes. The tubes were wrapped together. The plastic wrap was cut so that one tube could be picked up. As the employee was lifting the top tube, the other tube (still connected to the top tube) came down onto his hand and broke two of his fingers. He was hospitalized.

TEXAS PIPE AND SUPPLY COMPANY

An employee was assisting as a forklift got pipe from a pipe rack. The employee was on one of the forklift's forks as it was raised to the top of the rack, a height of about 15 feet. He fell to the ground and suffered a dislocated and fractured right elbow.

United Performance Metals, LLC

On September 23, 2025, at approximately 7:43 p.m., an employee was using a knife to cut poly banding from a metal coil. The knife slipped, causing a laceration to the inside of their left arm at the elbow joint. The employee was hospitalized and required surgery to repair a damaged vein.

Joseph T Ryerson & Son, Inc

An employee was using an overhead crane with a sheet lifter to move two stacks of carbon plates. They were standing in-between the two stacks as the sheet lifter lowered onto one of the stacks. The bundled material slipped out and the employee's right ankle was pinned against the other stack, resulting in a fractured leg and ankle that required hospitalization.

Main Line Clinical Labs

An employee was closing a door when the door closed on their right index finger, resulting in a fingertip amputation.

Ardent Mills

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

Zimmerman & Herr

An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.

McAneny Brothers, Inc.

An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.

Metz Culinary Management LLC

An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.