105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

EASTERN METAL SUPPLY, INC.

Contact incidents unspecified · Fractures

Federal OSHA recorded a severe workplace injury at EASTERN METAL SUPPLY, INC., 5330 Ashton CT., SARASOTA, FLORIDA 34233 on — Fractures , affecting the Other finger(s) n.e.c..

An employee and a customer were unloading two rectangular tubes. The tubes were wrapped together. The plastic wrap was cut so that one tube could be picked up. As the employee was lifting the top tube, the other tube (still connected to the top tube) came down onto his hand and broke two of his fingers. He was hospitalized.

Hospitalized Other finger(s) n.e.c. Pipes, tubes metal

Eastern Metal Supply, Inc.

An employee was removing the tarp from their flatbed trailer when a forklift went to retrieve a bundle and the forks caught another bundle. The bundle fell toward the employee and he jumped from the trailer to the ground, landing on his left side and fracturing his hip.

Eastern Metal Supply, Inc.

An employee was cutting material using a shear machine. She went to bring down the lever of the machine when her knee contacted the machine. The employee sustained a fractured knee.

Eastern Metal Supply, Inc.

The injured employee was holding a pallet rack upright while another employee disassembled the pallet rack. The opposite upright fell toward the injured employee, breaking four ribs and puncturing a lung.

Eastern Metal Supply, Inc.

An employee was on a trailer, unstrapping a load of metal sheets for roofing. The employee fell from the trailer to the ground and broke a rib.

Eastern Metal Supply, Inc.

An employee was operating a punch machine when the die amputated the tip of the employee's left index finger.

View EASTERN METAL SUPPLY, INC.'s full OSHA safety record →

HB Fleming, Inc.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Howard Industries Inc.

An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.

3S Services, LLC

An employee had been cleaning the work area. While lifting a saw, the employee's index finger was lacerated by the saw blade. A tendon was cut and required surgery.

Broad & James, Inc.

An employee was installing a hydraulic extension cylinder in a tow truck when their leg was caught between the cylinder and the truck frame. The employee was hospitalized with a broken tibia, which required surgery.

TRC Services of Texas INC

An employee was sorting sucker rods. His right hand was caught in the area where the rod hits up against the frame and his index fingertip was amputated just below the nail.

Triad Metals International

A load of steel angles was being lowered when the lifting chain hit the load, causing it to slide toward an employee. An angle slid and pinched the employee, catching both of their legs between the beams and an angle. The employee suffered two fractured legs.

Ryder System Inc.

An employee was on the deck of a trailer helping a customer unload tubes. The employee was working to place a cargo strap on the remaining tubes using a winch bar when it slipped off the tubing, causing him to lose his balance and fall headfirst onto the asphalt lot below. The employee suffered a contusion on his forehead, resulting in hospitalization.

TEXAS PIPE AND SUPPLY COMPANY

An employee was assisting as a forklift got pipe from a pipe rack. The employee was on one of the forklift's forks as it was raised to the top of the rack, a height of about 15 feet. He fell to the ground and suffered a dislocated and fractured right elbow.

United Performance Metals, LLC

On September 23, 2025, at approximately 7:43 p.m., an employee was using a knife to cut poly banding from a metal coil. The knife slipped, causing a laceration to the inside of their left arm at the elbow joint. The employee was hospitalized and required surgery to repair a damaged vein.

Joseph T Ryerson & Son, Inc

An employee was using an overhead crane with a sheet lifter to move two stacks of carbon plates. They were standing in-between the two stacks as the sheet lifter lowered onto one of the stacks. The bundled material slipped out and the employee's right ankle was pinned against the other stack, resulting in a fractured leg and ankle that required hospitalization.

DRIFTWOOD NURSERY & LANDSCAPING, INC

An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.

Hobby Lobby Stores, Inc.

An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.

Envelope Seal Insulation, Inc

An employee was inspecting a generator whose radiator was leaking. He slipped, and a fan blade in the generator amputated his thumb and index finger.

Sugar Cane Growers Cooperative of Florida

An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.

Air-flo/Erwood Heating & Air Conditioning

An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.