Direct exposure to electricity, unspecified · Electrocutions, electric shocks
At a glance
Federal OSHA recorded a severe workplace injury
at Bentley-Miller Arby's of South Dakota, 319 West Sioux Avenue, PIERRE, SOUTH DAKOTA 57501
on — Electrocutions, electric shocks, affecting the bODY SYSTEMS.
Watch Bentley-Miller Arby's of South Dakota — freeGet an email when a new federal OSHA severe-injury report for Bentley-Miller Arby's of South Dakota is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee was training another employee on how to clean the shake machine when the shake machine expelled excess cleaning solution onto an electrical outlet. The employee unplugged the shake machine's cord from the outlet and was shocked.
An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.
An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.
An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.
An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.
On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.
More severe injuries in this industry (NAICS 722513)
An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.
An employee was kneeling on the ground while painting in a hotel area. He felt a prick, then overnight had a lot of pain, irritation, and some swelling. The employee was hospitalized with an infection in his knee.
A contractor was performing maintenance on a fryer when it tipped over, causing hot oil to splash onto the injured employee, who was nearby. The injured employee suffered burns that required hospitalization.
An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.
An employee was walking past a crossover conveyor when a ramp came down and hit them in the back. The employee sustained a broken back vertebra, as well as a concussion, and was hospitalized.
An employee was using a hook tool to pull a pallet onto the lift gate of a tractor trailer. The hook detached from the underside of the pallet, causing the employee to fall backward off the lift gate. The employee landed on the concrete parking lot about 5 feet below, suffering fractures to the skull and two thoracic vertebrae.
An employee was walking on a truss table when he lost his balance and fell approximately 3 feet to the floor. The employee sustained a dislocated and fractured left ankle.