Pedestrian struck by forward-moving vehicle in nonroadway area · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at TLM Constructors, Inc, I -25 at exit 59, WALSENBURG, COLORADO 81089
on — Fractures, affecting the foot (feet), unspecified.
Watch TLM Constructors, Inc — freeGet an email when a new federal OSHA severe-injury report for TLM Constructors, Inc is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee was connecting a water pump on a truck when the truck driver pulled forward, running over and fracturing the employee's right foot.
HospitalizedFoot (feet), unspecifiedTruck-motorized freight hauling and utility, unspecified
On December 30, 2023, an employee was pulling a pallet into the back room when a forklift rounded the corner and ran over the employee's right foot. Three of the employee's toes were amputated.
An employee was unwrapping a pallet of empty buckets. The employee stepped backward and was struck by a powered industrial truck carrying a pallet of bucket lids, resulting in a left ankle fracture.
An employee was walking in the racking area to check parts when they were struck by an oncoming forklift. The front wheel ran over the employee's right leg, resulting in fractures to the leg and ankle.
An employee was exiting a trailer for it to be loaded when their right ankle was pinned between a piece of angle iron that was anchored to the floor and a long pallet being pushed by a powered industrial truck (PIT). The employee sustained an ankle fracture and was hospitalized.
A tow truck operator was operating his bed controls on the drivers side when another vehicle crashed into him. The employee sustained fractures to the right femur, hip, and left foot, as well as abrasions to the right knee and a laceration to the right wrist.
More severe injuries in this industry (NAICS 237310)
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.
A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.
An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.
An employee was working with paving equipment and heard a noise on the opposite side of the machine he was working on. When the machine stopped, the employee went to the opposite side and crouched down to investigate the noise. A mini track loader backed up and drove over the employee's leg. The employee sustained fractures to their lower leg, ankle, and foot.
An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.
An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.
A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.
An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.