105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

JSM and Associates, LLC

Struck by falling object or equipment, unspecified · Amputations

Federal OSHA recorded a severe workplace injury at JSM and Associates, LLC, 8500 Pena Blvd, DENVER, COLORADO 80249 on — Amputations, affecting the finger(s), fingernail(s), unspecified.

Watch JSM and Associates, LLC — free Get an email when a new federal OSHA severe-injury report for JSM and Associates, LLC is published. One employer, no account, unsubscribe in one click.

An employee was trying to install a motor when the motor slipped and he tried to catch it. His fingers were pinched between the motor and the bracket, partially amputating two fingers.

Amputation Finger(s), fingernail(s), unspecified Motors other than vehicle

Amazon FTW5

An employee was unloading a trailer when a box fell and struck the employee in the face. The employee suffered a concussion and was hospitalized.

Tuff Shed, Inc.

An employee had been cutting lumber for a shed wall. A load of 16-foot trim pieces fell onto the employee causing vertebrae and ankle fractures.

Lufkin Industries

An employee was unloading 30-foot 2-inch barrels from a pan holding about 20 barrels. The barrels tipped over, striking and breaking both of the employee's lower legs.

Cy-Fair Coatings Inc

An employee was in a sandblasting area, preparing the surface of a plate heat exchanger frame for painting. The frame fell on the employee, who suffered fractures to vertebrae, the neck, pelvis, and rib cage; and punctured lungs.

Rodriguez General Carpentry

An employee was installing doors when one of the doors fell on him, fracturing his lower leg. The employee was hospitalized.

NATIONAL MILL MAINTENANCE, LLC

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

Elkhorn Mechanical and Combustion

An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.

Crown Lift Trucks

An employee was operating a lift truck when it struck a stationary lift truck. His left thumb was pinched between the two lift trucks, resulting in a partial amputation.

Spellman High Voltage Electronics Corporation - Valhalla

An employee was disassembling a pressurized unit using a driver drill. When the unit was disassembled, it caused a kickback from the tube head, causing the drill to strike the employee's left forearm. They sustained a diaphyseal fracture to their left radius and ulna, which required surgery.

Ring Power Corporation

After repairing a piece of industrial equipment, an employee had brake-cleaning liquid on his gloves. A lighter ignited the liquid, and the employee's hands were severely burned.

ABC Supply Company

An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.

Burke Builders Inc

An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.

Circle Graphics, Inc.

An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.

FLATIRON CONSTRUCTION CORP.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

Takkion OPS Management

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.