Southland Contracting, Inc.

An employee was running pipe into a hole on a rig floor. He was still running the other joint into the hole when the laydown machine shot the joint of pipe. The pipe hit the employee in the jaw and he fell backward, suffering a fractured cheekbone.

An employee was in the yard area on a forklift pulling lumber. Inclement weather began and the employee stopped the forklift and was walking to a safe location when they were struck by flying debris from the high winds or tornado. The employee sustained a leg fracture.

An employee was working at a job site when something flew into his eye. He was hospitalized with a cut on his cornea.

After reassembly work on a ready-mix truck, an employee turned the truck on to check for leaks. The employee was standing on the truck platform, about 3 feet off the ground, when he heard an air leak. As he was turning off the truck, a flying bolt from the plate assembly struck his forehead and broke his skull. He was hospitalized.

An employee was using an air hammer when a piece of metal struck their eye.

An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.

An employee fell while stepping off the tailgate of a pickup truck. The employee landed on the ground and suffered a broken left fibula and tibia.

On October 7, 2025, employees were conducting trenching operations for the installation of a new sewer line system. The excavator's bucket was detached and put inside the trench as it was being exchanged for a different-sized bucket. An employee entered the trench with a shovel to move some dirt located at the front end of the pipe. The excavator bucket shifted and slid, striking the employee s right foot and trapping it against the ground. The employee sustained a fractured right tibia.

Employees were working to dislodge a large truck that was stuck in a rut using tow straps and a front-end loader with the bucket removed. An employee connected the straps to the loader and truck and another employee slowly engaged the loader to close the coupler. The injured employee's arm became caught in a pinch point. The employee was hospitalized with a fractured arm.

An employee was lifting a piece of 30-inch line stopping equipment using a jack screw. A lifting eye weld snapped and the load dropped. The end of the jack screw then landed on the employee's heel and crushed it. The employee was hospitalized.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.