Federal OSHA recorded a severe workplace injury
at Quality Steel & Welding, INC, 1 Edison Dr, ALPHARETTA, GEORGIA 30022
on — Fractures, affecting the back, including spine, spinal cord, unspecified.
Final narrative
An employee was operating a telehandler forklift while wearing his personal fall protection harness. When he went to back up, a lanyard that was hanging down and not attached to the harness caught under the front wheel and jerked him violently in his seat. He was wearing his seat belt at the time. He struck the metal guards on the side seat of the forklift and fractured vertebrae in his back.
HospitalizedBack, including spine, spinal cord, unspecifiedForklift, order picker, platform truck-powered
An employee was using a dozer to clear a plot of land. The dozer struck the ground after getting stuck on a tree stump, causing the employee to hit their head on the cab roof. The employee sustained a spinal compression injury.
On August 31, 2023, an employee was operating an excavator to complete a demolition job. As the excavator drove into the first floor of the building, the floor collapsed. The vehicle and employee dropped approximately 8 feet, causing the employee to sustain a back injury.
An employee was standing on a walk-behind lawn mower when the mower spun out of control. His right ring fingertip became caught in the handlebar, resulting in an amputation.
An employee was loading a bundle of 3/8-inch rebar using a standup skid loader. While transporting the load, the equipment tipped forward, throwing the employee over the controls and into the mast of the skid loader. The employee sustained several teeth avulsions, a mouth laceration, and bruising/swelling around the face.
An employee was driving a forklift to deliver lumber to a work site when the forklift tipped forward onto the forks. The employee struck his head on a metal railing on the forklift, resulting in a laceration, a concussion, and temporary loss of consciousness.
More severe injuries in this industry (NAICS 333992)
An employee was moving metal out of a cart. He had removed one piece and was working to move another when the metal shifted. His right ring finger was crushed between the two pieces, and he suffered a partial amputation to the finger pad at the tip.
An employee was at the loading dock working to manually move an oversized load off of a pallet that was sitting on another pallet. The oversized load (a gas cylinder cradle) tipped over and crushed the employee's right leg against the ground. The employee sustained a fracture to their ankle/leg requiring surgery.
An employee was depressurizing a line stop actuator when their left arm was struck by a threaded, 2-inch nipple from the side of the line stop housing. The employee sustained fractures to their left arm and a rib.
An employee was cutting the top of an empty scrap barrel that previously contained antifreeze. The bottom of the barrel blew out due to pressure that built up and caused his jeans to catch fire, resulting in burns.
An employee was moving extra wire out of a cleaning tank by using the tank's jogging function. Two of the employee's right-hand fingers were caught on the last strand going around the acid roll, and the employee suffered an amputation to the right little fingertip.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.