Struck by object falling from vehicle or machinery-other than vehicle part · Cuts, lacerations
At a glance
Federal OSHA recorded a severe workplace injury
at James Hardie Building Products, 820 Sparks Drive, CLEBURNE, TEXAS 76033
on — Cuts, lacerations, affecting the toes(s), toenail(s).
Final narrative
While walking into an office, an employee entered the path of a forklift that was carrying metal siding. The forklift shifted, causing the siding to fall off the forklift and land on the employee's foot. He suffered toe lacerations. Steel-toed boots were worn at the time of the incident.
An employee was unloading an auto clave, stepped off of a concrete auto plate located outside of the work platform, and fell approximately 18 inches into a condensate drain. The drain contained hot water at a temperature of 170 degrees. The employee sustained second degree burns.
An employee was cutting siding into 2-inch strips using a circular saw on a saw horse. The strip started to buckle; the employee reached to grab it, cutting the palm at the finger joint.
An employee was transporting an 800-pound die on a cart from the tool room. The employee was pulling the cart when it struck a metal plate on the floor. This caused the cart to tip forward and the die to slide off the cart. The die struck the employee's left foot and their second toe was amputated.
An employee was using a forklift to load pallets of product on a trailer. He exited the forklift to adjust a pallet by hand. The pallet fell on him, resulting in an injury to the left leg.
An employee was lifting a 500-pound steel counterweight off a pallet using a magnetic hold jib crane. The counterweight detached from the crane and the employee sustained a left foot/toe fracture that required surgery.
An employee was using a pipe wrench to turn a 42-foot-long steel pipe on jack stands to weld the bottom portion. The pipe fell off the stands, striking the injured employee on his left shin. The employee sustained a left leg fracture at the shin area as well as a tibia fracture that required surgery.
More severe injuries in this industry (NAICS 238290)
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.
An employee was assisting with cutting a vertical steel pile. A 16-foot by 9-inch section of pile dropped to the side and bounced off a previously cut pile and toward the employee. The employee was struck in the torso and leg, causing his knee to dislocate from his femur. The employee was hospitalized.
On July 30, 2025, an employee was utilizing a circular saw to cut plastic into strips that would be used as shims. The blade of the saw amputated his left little finger to the second knuckle.
An employee was working on the ingot loader of a aluminum processing machine and noticed a pin was not installed. The employee reached to retrieve the pin and the machine activated for a functions test. The machine closed on the employee's hand, resulting in a hand injury requiring hospitalization.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.