Vehicle or machinery fire · Heat (thermal) burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Hammett Excavation Inc., 1201 N. Central St., FERRIS, TEXAS 75125
on — Heat (thermal) burns, unspecified, affecting the multiple body parts, n.e.c..
Final narrative
An employee was refueling his equipment (track-hoe) when he noticed a few sparks occur once he touched the fuel nozzle to the neck of the fuel tank opening. He went to pull the nozzle out and a burst of flames shot out, causing burns on his right arm and the right side of his face.
HospitalizedMultiple body parts, n.e.c.Backhoes, trackhoes
An employee removed the spark plugs and was rotating an engine to evacuate condensate from the cylinders. An unknown source ignited the condensate and natural gas. The employee sustained burns to the back of his hands and upper leg area.
An employee was operating a front-end loader when a hydraulic line broke, causing the front-end loader to catch on fire. The employee jumped from the cab to the ground and sustained fractures to the T-6 vertebra and a heel.
An employee was moving two totes of turpentine. Noticing that one of them was leaking, he stopped his forklift and began to look for the leak. The forklift caught fire, and the employee suffered severe burns. He was hospitalized.
An employee was performing maintenance on a machine when part of an adjacent machine caught fire. The employee extinguished the fire and suffered smoke inhalation.
More severe injuries in this industry (NAICS 562212)
A driver had backed up a rear load truck to a dumpster. The winch cable was bound, and another employee went to use the controls to put slack in the line. The cable tightened instead of loosening while the driver was holding it, and it caught his hand against the truck and crushed his thumb. The thumb was fractured and lacerated; he was hospitalized, requiring surgery. The incident took place during a training activity.
An employee was pulling into a customer's parking lot to pick up a roll-off container when the vehicle ran over the median curb. The vehicle then veered to the left, striking the side curb and the retaining wall. The employee sustained injuries to his neck and spine, as well as a damaged artery, a head laceration, and fractured ribs.
An employee was replacing the bracing arm of a baler. The replacement part (weighing an estimated 500 pounds) was moved into place using a truck-mounted crane with a lifting strap attached to the designated pick point. The employee then used his right hand to stabilize/align the part. The part shifted, crushing his right index finger against the mounting pin hole. The employee's finger was amputated above the first knuckle.
An employee was moving a mower with a tractor bucket when the bucket slipped and struck another employee on the hand. The injured employee sustained a partial amputation of their left little finger.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.