105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

TAMPA ELECTRIC COMPANY

Compressed or pinched by shifting objects or equipment · Soreness, pain, hurt-nonspecified injury

Federal OSHA recorded a severe workplace injury at TAMPA ELECTRIC COMPANY, 3429 W. Spruce St., TAMPA, FLORIDA 33607 on — Soreness, pain, hurt-nonspecified injury, affecting the finger(s), fingernail(s), unspecified.

An employee was helping to offload a 267-pound cement load-bearing handhold from the flatbed of a truck when his left hand was caught under the handhold, injuring two fingers. He was hospitalized and had surgery.

Hospitalized Finger(s), fingernail(s), unspecified Parts and materials, unspecified

Tampa Electric Company

An employee was changing fuel filters on a front-end loader. When he descended the access steps of the engine bay, he misstepped and fell approximately 3 feet to the concrete surface below. The employee sustained a fractured left hip.

Tampa Electric Company

Employees were preparing to replace a primary electrical cable. While two of the employees were working to remove the cable on one side of a switchgear, they came into contact with a wrench and the outside part of the switchgear. One employee suffered an electrical shock.

Tampa Electric Company

An employee was working outside, sustained a heat-related illness, and was hospitalized.

TAMPA ELECTRIC COMPANY

An employee was assisting in the movement of a reel of steel wire onto a truck using a forklift and a sling. The load became stuck on a stanchion and the employee pulled up on the load, causing the employee's hand to become caught/crushed between the reel and the boom of the forklift. The employee sustained two hand fractures.

TAMPA ELECTRIC COMPANY

An employee was replacing seal rings on a valve strainer. After isolating the valve and bleeding off steam, the employee was removing a plate holding the seal ring when water released within the strainer and valve. The water contacted hot metal, which caused it to steam. The steam contacted and burned the employee's stomach and upper legs.

View TAMPA ELECTRIC COMPANY's full OSHA safety record →

TForce Freight

An employee was operating a forklift and unloading a truck. After the truck was unloaded, the employee got off the forklift and proceeded to adjust the dock plate with a hook tool. The dock plate slipped and the employee went to adjust the plate with their hand when their left middle finger got caught. Their finger was amputated above the first joint.

Liveo Research, Inc.

An employee was rotating a carbide granulator blade when his finger was caught between the blade and a stationary part of the machine. The employee's right middle finger was partially amputated and they suffered an avulsion to the right ring fingertip.

Best Pump and Flow

An employee was using a CNC metal lathe machine in manual mode to check that the thread blocking tool made contact with the jaws. As the employee was manually spinning the spindle, his index fingertip was crushed between the spindle's jaws and the grooving insert, resulting in a fingertip amputation.

FORD MOTOR COMPANY

During a material handling operation, an employee's fingertip was caught under an air conditioning unit as the unit was lowered onto a cart. The employee's fingertip was amputated.

Lasseter Tractor Company. Inc.

An employee was removing a bolt from a tractor hub when their right index finger was caught between the hub and the frame. The employee's fingertip was crushed and the employee was hospitalized.

American Electric Power Company

An employee was setting up communication equipment for a meeting. They were walking and tripped over a speaker on the ground. The employee sustained a leg injury.

Cherokee Electric Cooperative

An employee (a lineman) was working to restore power by installing a hand line when he contacted a high-voltage device (7,200 volts), resulting in electrical burns to his upper body and hands.

Centerpoint Energy Houston Electric, LLC

A chain sling failed while a utility pole was being removed. A chain link struck an employee who was operating a front-end loader, puncturing the employee's chest.

Public Service Electric & Gas

An employee was working with an underground crew to troubleshoot a BUD failure. The employee was removing a fuse from the fuse holder when the fuse blew on the riser and an arc flash occurred. The employee was hospitalized with burns to his face, nose, lips, and neck.

Bright Star Solutions, Inc

An employee was connecting two wires when his rubber insulated gloves failed and he suffered an electric shock to his right hand, resulting in an electrical burn.

DRIFTWOOD NURSERY & LANDSCAPING, INC

An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.

Hobby Lobby Stores, Inc.

An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.

Envelope Seal Insulation, Inc

An employee was inspecting a generator whose radiator was leaking. He slipped, and a fan blade in the generator amputated his thumb and index finger.

Sugar Cane Growers Cooperative of Florida

An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.

Air-flo/Erwood Heating & Air Conditioning

An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.