ST Paper, LLC

An employee was adjusting wire on a wet lap machine when their left arm was crushed in an in-going nip point.

An employee was assisting with pipe on a drilling rig. The slips came down and landed on the employee's left foot fracturing four metatarsals.

Two employees were struck by the rotary table of a drilling rig while installing caisson. Employee 1 suffered multiple fractures, internal injuries, and head trauma. Employee 2 suffered multiple fractures, internal injuries, spinal injury, and head trauma.

Employees were felling hazard trees. The injured employee was conducting 'bucking' operations to saw a tree from the road when the tree kicked-back, pinning him against the ground and fracturing his left femur. The employee was hospitalized and required surgery.

An employee was greasing tongs on a work-over rig. The tongs lacerated one of the employee's fingers.

An employee was chaining a vehicle when he had to change tools and the compressor. As the compressor was being charged, the employee stepped near the vehicle to make sure the compressor was attached. Then, he instructed a co-worker to lower the compressor. His right hand was on the compressor and under the chain, causing his ring finger to be crushed.

An employee was loading black liquor into a tanker truck using a swivel arm. The arm caught and pinched his right middle finger as it moved, resulting in a partial amputation to the first knuckle.

An employee was visually inspecting the drive line for a conveyor. There was an explosion in the conveyor, and the employee suffered second- and third-degree burns to both forearms.

An employee was driving forklift with a load when the forklift hit a guardrail and the employee fell to the ground, resulting in a broken elbow, broken shoulder, and lacerations.

An employee was putting a chain back on a sprocket. The gearbox and sprocket contained two drive chains connected to the lowerator (vertical conveyor) and counterweight assembly. The employee received an alarm indicating that one of the chains had gone slack. While the employee was putting the chain back on the drive sprocket with tongue and groove pliers, the weight of the chain and counterweight fell back in place on the sprocket, pulling the employee's left hand into a pinch point. The employee's ring fingertip was amputated up to the fingernail.

While troubleshooting equipment, an employee tripped on the turntable of the conveyor system and fell to the floor, fracturing their right femur.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.